《毕业设计(论文)-1.3万吨年中等分子量聚丙烯酰胺干燥设备设计》.docVIP

1.3万吨/年中等分子量聚丙烯酰胺干燥设备设计摘 要 关键词：聚丙烯酰胺；干燥器；卧式多室流化床Abstract This design source is through the two polymerization in polymers, and two workshop internship on synthesis of polypropylene acyl overall production process analysis and drying equipment for its analysis, from literature, books and network understand the development of drier and various kinds of dryer advantages and disadvantages. Through consulting relevant design fluidized bed drier Chinese and foreign documents, and relevant PAM physical and chemical properties and synthetic methods and the application of polyacrylamide development present situation and prospect of horizontal more comprehensive analysis, design room fluidized bed drier. Design content including dryer subject technical calculation and dryer accessory equipment selection and calculation. This paper comprehensively expounded of polyacrylamide drying equipment, and process flow and principle of dryer to carry on the design, through the work of material balance dryer is, energy can be determined, the bottom of drier area and the height of the drying system, drawing with the flow chart and control plan, complete drying device workshop assembly drawings. The calculation and checking, dryer design results basic meets the requirement Keywords: PAM; Dryer; Horizontal multi-oven fluidized bed 目录第一章 前言……………………………………………………………………………1 1.1 聚丙烯酰胺的发展…………………………………………………………………1 1.2 聚丙烯酰胺的种类………………………………………………………………1 1.3 聚丙烯酰胺的性质…………………………………………………………………2 1.4 聚丙烯酰胺的主要特点…………………………………………………………2 1.5 干燥器的分类与选择………………………………………………………………3 1.5.1 干燥器的分类……………………………………………………………3 1.5.2干燥器的选择……………………………………………………………4 第二章 设计内容概述…………………………………………………………………5 2.1 工艺原理和设计目的………………………………………………………………5 2.1.1工艺原理…………………………………………………………………5 2.1.2设计目的……………………………………………………………………5 2.2干燥流程简介及卧式多室流化床干燥意义简介…………………………………5 2.3干燥器的设计……………………………………………………………………6 2.3.1 操作条件及基本物性数据……………………………………………7 2.3.2 设计分析…………………………………………………………………7 2.4工艺计算…………………………………………………………………………7 2.4.1 一段干燥工艺计算………………