《毕业设计(论文)－无线家居监控系统》.docVIP

PAGE 43 无线家居监控系统 摘要：本系统是以AT89S52为现场控制器，以ARM主控制器，它们辅以CC1100无线通信模块、温度传感器DS18B20、烟雾报警模块、PWM调光模块组成，实现温度信号的无线传输以及显示、亮度的无线传输显示和烟雾报警。系统使用51单片机采集温度，亮度和烟雾报警信息，然后通过CC1100无线模块将数据发射到ARM；ARM通过CC1100无线模块接收数据然后显示温度和亮度、也可以通过触摸屏来控制51单片机端的LED的亮度和对报警信号进行处理。最终完成了温度、亮度和烟雾信号的准确采集及CC1100的双向通讯，实现对家居的安防和控制。 关键词：ARM9；S3C2440;DS18B20；CC1100；PWM调光 Wireless home monitoring system Abstract：The system is based on AT89S52 site controller and based on the ARM host controller they are supplemented by CC1100 wireless communication module, temperature sensor DS18B20, smoke alarm module, PWM dimming modules, wireless transmission of temperature signals and display brightness wireless transmission display and smoke alarms. 51 single-chip system uses collecting temperature, brightness and smoke alarm information, and then through the CC1100 wireless module to data emission to the ARM; the ARM CC1100 wireless module to receive data and then display the temperature and brightness, also can via the touch screen to control the brightness of the 51 single-chip side of the LED and alarm signal for processing. Finally to complete the two-way communication of accurate acquisition of temperature brightness and smoke signals. Keywords: ARM9; S3C2440; DS18B20; CC1100; PWM dimming 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc320869801 1 引言 PAGEREF _Toc320869801 \h 2 HYPERLINK \l _Toc320869802 2 本设计的任务和基本要求 PAGEREF _Toc320869802 \h 3 HYPERLINK \l _Toc320869803 3 设计方案及硬件电路结构 PAGEREF _Toc320869803 \h 4 HYPERLINK \l _Toc320869804 3.1 总体系统设计 PAGEREF _Toc320869804 \h 4 HYPERLINK \l _Toc320869805 3.2 主控模块的选择及硬件实现 PAGEREF _Toc320869805 \h 4 HYPERLINK \l _Toc320869806 3.2.1 ARM芯片 PAGEREF _Toc320869806 \h 5 HYPERLINK \l _Toc320869807 3.2.2 SDRAM存储系统 PAGEREF _Toc320869807 \h 6 HYPERLINK \l _Toc320869808 3.2.3 Flash的存储系统 PAGEREF _Toc320869808 \h 7 HYPERLINK \l _Toc320869809 3.2.4 LCD触摸屏系统 PAGEREF _Toc320869809 \h 8 HYPERLINK \l _Toc320869810 3.3 现场控制器的选择及硬件实现 PAGEREF _Toc320869810 \h 8 HYPERLINK \l _Toc32