CCNA 4-6 EIGRP.pptVIP

EIGRP Implementation Implementing EIGRP EIGRP Features EIGRP Tables EIGRP Path Calculation (Router C) EIGRP Configuration EIGRP and Discontiguous Networks Default Scenario Configuration EIGRP and Discontiguous Networks with no auto-summary Verifying the EIGRP Configuration Verifying the EIGRP Configuration (Cont.) Verifying the EIGRP Configuration (Cont.) Verifying the EIGRP Configuration (Cont.) debug ip eigrp Command EIGRP Metric The criteria that EIGRP uses by default to calculate its metric: Bandwidth Delay The optional criteria that EIGRP can be configured to use when calculating its metric: Reliability Load Note: Although MTU is exchanged in EIGRP packets between neighbor routers, MTU is not factored into the EIGRP metric calculation. EIGRP Load Balancing By default, EIGRP does equal-metric load balancing: By default, up to four routes with a metric equal to the minimum metric are installed in the routing table. There can be up to 16 entries in the routing table for the same destination: The number of entries is configurable with themaximum-paths command. EIGRP Unequal-Cost Load Balancing Variance Example EIGRP MD5 Authentication EIGRP supports MD5 authentication. The router identifies itself for every EIGRP packet it sends. The router authenticates the source of each routing update packet that it receives. Each participating neighbor must have the same key configured. EIGRP MD5 Authentication Configuration Steps Create the keychain, a group of possible keys (passwords). Assign a key ID to each key. Identify the keys. (Optional) Specify the duration a key will be valid. Enable MD5 authentication on the interface. Specify which keychain the interface will use. Configuring EIGRP MD5 Authentication Configuring EIGRP MD5 Authentication (Cont.) Configuring EIGRP MD5 Authentication (Cont.) Example EIGRP MD5 Authentication Configuration Example EIGRP MD5 Authentication Configuration (Cont.) Verifying MD5 Authentication Visual Objective 5-1: Implementing EIGRP