自动化装置-FCS3-HART.pptVIP

2. COMMAND #1 READ PRIMARY VARIABLE Read the Primary Variable. The Primary Variable is returned in floating point format. 3. COMMAND #2 READ P. V. CURRENT AND PERCENT OF RANGE Reads the Primary Variable as Current and a percent of the Primary Variable Range. The Primary Variable Current always matches the Analog Output current of the device including alarm conditions and set values. Percent of Range always follows the Primary Variable, even if the Primary Variable Current is in an alarm condition or set to a value. Also, the Percent of Range is not limited to values between 0% and 100%, but tracks the Primary Variable beyond the Range Values to the Sensor Limits when they are defined. 4. COMMAND #3 READ DYNAMIC VARIABLES AND P. V. CURRENT Read the Primary Variable Current and up to four predefined Dynamic Variables. The Primary Variable Current always matches the Analog Output current of the device including alarm conditions and set values. The Secondary, Tertiary, and 4th Variables are defined by each device type (e.g. the Secondary Variable is the Sensor Temperature for the 3051 Pressure Transmitter). 主机到从机 FF FF FF FF FF 82 A6 06 BC 61 4E 01 00 B0 上面是主机到从机发送的一条消息。前5个字节值都为FF，显然他是导言字节。接着的82起始字节，表示主机到从机发出的长结构的消息。后5个字节 “A6，06，BC，61，4E”是地址字节化为二进制表示如下： A6 06 BC 61 4E 1010 0110 0000 0110 1011 1100 0110 0001 0100 1110 可见首字节A6的最高位为1表示主机，次高位为0表示非突发模式，后面的38 b表示设备的惟一标号： “100110”是生产厂家代码，值为38，是Rosemount公司的代码；后一字节06是设备型号代码，06代表的型号是3051C；后面的3个字节是设备识别号，本例中的值再接下来的01是命令字节，表示1号命令，即读取PV值 例3：突发模式 FF FF FF FF FF 81 53 03 04 E6 D7 03 1A 00 60 41 3F A0 00 27 41 3F A0 00 39 42 47 60 00 06 BF 06 60 00 39 41 95 00 00 D4上面是突发模式发出的一条消息。第1个字节81表示突发的长结构模式，与前例中相似的地方我们不再介绍。注意到状态字节“00 60”后的字节“41 3FA000”，他表示的是当前的电流值，计算后是11．976 6；后面的27表示单位mA，像后面的39表示“％”一样。数据字节中的“42 47 60 00”，“BF06 60 00”，“41 95 0000”分别表示“SV”，“TV”，“FV HART 开发准备工作 HART Protocol Specification MODEM Chip Smar Research HT2012 LSI Logic SYM20C15 Development Tools host testing application bus an