DifIEC61215第三版本差异分析.ppt

Department name TüV SüD Group TüV SüD Group Department name Difference between IEC 61215 ed2 and ed3 draft TüV SüD PHOTOVOLTAICS Xiangxi Bo 2011-08-27 Tel : +86/ (0) 512 6809 5318 - 105 Fax: +86/ (0) 512 6809 5328 Mail: David.bo@ IEC PV Certification Department name * IEC ISO ITU Standard Management Board Conformity Assessment Board IECEE TC82 Central Office Other TC IECQ IECEx CTL ETF-9 NCB CBTL WG2 flat panel WG3 System WG6 BOS WG7 CPV PV * Overview 3rd edition includes the following significant technical changes with respect to the 2nd edition: Maximum power at STC has been made a pass/fail criteria. b) Added retest guidelines. c) Completely changed the hot spot test. d) Update the other tests to be consistent with changes in IEC 61646. e) Removed the method for measuring temperature coefficients and refer to IEC 60891. f) Combined the NOCT test with the Outdoor exposure test and renamed the resultant temperature as NMOT. PV * IEC 61215 2nd v.s. IEC 61215 3rd Item Chapter/Clause Details 1 4 Marking Added: nominal and minimum values of maximum output power at STC after preconditioning, as specified by the manufacturer for the product type (Section 5) 2 5 Testing Modified: preconditioning changed from 5-5.5 kWh x m-2 to 5-20 kWh x m-2, After this preconditioning all of the test modules shall be measured for STC power. (10.2) 3 5 Testing Added: 10.4, 10.5, 10.6 and 10.7 may be omitted at the discretion of the customer Department name * 4 5 Testing Add: The order of tests in the “electrical and thermal performance sequence” is not important although tests 10.4, 10.5 and 10.6 must be performed before the subsequent stress tests 10.8, 10.18 and 10.9. If desired separate modules may be utilized for 10.8, 10.18 and 10.9. 5 6 Pass criteria Added: The STC power measured in 10.2 shall meet the manufacturer’s power rating range after preconditioning. Note: The pass/fail criteria must consider the laboratory uncertainty of the measurement. As an example if