芯片的烧写方法.docVIP

CPU芯片：单片机PIC16F876 烧写器：SUPERPRO/L+ 烧写步骤：1..接烧写器的电源和烧写器与电脑连接的并口线。 2．将PIC单片机插入烧写器，单片机的第一个管脚插入上数第5个插槽（如图4所示）。 3．打开烧写器电源，运行SUPERPRO/L+的软件，运行后界面如图1所示。 图1：打开烧写器画面 4．首先点击“器件”按钮，选择MICROCHIP公司的PIC16F876A单片机，然后单击“确定”，画面如图2所示。接下来弹出重要信息窗口（如图3所示），关闭该窗口，然后弹出图4所示的窗口。从图4中也可看出如何将芯片插入烧写器的插槽中。 图2：选择器件画面 图3：重要信息画面 图4：适配器画面 5．单击“打开”按钮，选择光盘上的“GL.HEX”文件，单击打开，如图5所示。弹出文件类型画面，如图6所示。在文件类型对话框中选择INTEL，单击确定后，此时弹出编译画面如图7所示。 图5：打开文件画面 图6：文件类型选择画面 图7：编译画面 6．单击“运行”按钮，弹出器件操作画面如图8所示，单击“配置字”，弹出配置字画面，如图9进行设置，然后点击确定。在器件操作画面选择erase_chip,单击运行，擦除器件原有的信息，画面如图10所示。在器件操作画面，选择program,单击运行，画面（如图11所示），进行程序烧写。烧写过程会持续十几秒钟。等芯片烧好后可取下芯片，烧写完成。 图8：器件操作画面 图9：配置字画面 图10：器件擦除画面 图11：器件烧写操作画面 注意：在烧写前一定要设置配制字，否则芯片不能正常工作。如果在烧写过程出现错误，可能是因为芯片损坏、并口电缆没连接好或烧写器未开电源。 staff and workers representativesThe representatives of the staff and workers from the unit or away from retirement, on behalf of automatically disqualified, on behalf of the delegation to the original vacancy shall be in accordance with the provisions of the election.Replace the fourteenth representatives of the staff and workersThere are the representatives of the employees, who have the right to change the unit:1, due to illegal law and discipline punishment;2, often without reason not to participate in the activities of the staff representatives of the staff and the organization of the work of the organization, a serious dereliction of duty;3, because of unpaid leave, sick leave and long-term, full-time study and so on, not to participate in the activities of the post of the staff and workers congress;4, removed from the unit, from the original delegation.The rights of the representatives of the fifteenth employeesFirst, the incumbent will have the right to vote in the election, the right to vote and the right to vote.Two, have the right to participate in the Congress and its working mechanism in the company. Check all relevant departments to carry out the workers congress resolution and proposal to implement the situation, have the righ