- 32
- 0
- 约3.01万字
- 约 14页
- 2017-01-03 发布于重庆
- 举报
2001年辽宁省成人本科生
学士学位英语通考试题(上半年)
注意事项 :
一、将答题纸上的学校、姓名、准考证号等项用中文填好。
二、仔细阅读题目的说明。
三、在120分钟内答完全部试题。
四、答案一定写在答题纸上,凡是写在试题册上的答案一律作废。
五、选定答案后,用HB以上浓度的铅笔把相应字母涂黑。正确方法是:[A] [B] [C] [D]
六、如要改动答案,必须先用橡皮擦去原来选定的答案,然后再按上面的规定重新答题。
七、主观试题用钢笔或圆珠笔书写。
Part I Phonetics (1 x 10 = 10 Points)
Directions: In this part, there are ten groups of words. From the A, B, C and D choices, choose the
word with the underlined part the pronunciation of which is the same as the word given. Then mark the corresponding letter on the Answer Sheet with a single line through the centre.
1. valid A. vacation B. vanity C. vapor D. variety
2. generate A. genius B. gesture C. interpret D. intermediate
3. naked A. learned B. glittered C. inclined D. marked
4. musical A. muscle B. multiple C. suspect D. supreme
5. package A. adequate B. decorate C. tolerate D. operate
6. topic A. co11ar B. obey C. post D. pollution
7. soul A. cough B. should C. shoulder D. route
8. exceed A. exactly B. excuse C. exploit D. expectation
9. shiver A. shift B. ski C. stripe D. shining
10. month A. northern B. mouths C. paths D. births
Part II Reading Comprehension (1.5 x 20=30 Points)
Directions: There are 4 reading passages in this part. Each passage is followed by some questions or unfinished statements. For each of them there are four choices marked A, B, C and D. You should decide on the best choice and mark the corresponding letter on the Answer Sheet with a single line through the centre.
Passage One
The factory was completely silent. The assembly line had stopped, leaving the shells of cars still and empty-looking without their wheels and glass. The robots used for spot-welding bent ove
您可能关注的文档
最近下载
- 偷窥漫画第一季完整.docx VIP
- 走向成熟(青春期男生性教育).ppt VIP
- 2025年上海市中考语文试卷真题(含答案解析).pdf
- 内蒙古房屋市政工程建设、监理、施工单位施工现场安全资料用表.pdf VIP
- 附表C 施工单位施工现场安全资料用表.doc VIP
- 2025年中小学教师副高水平能力测试题(附答案).docx
- 深度解析(2026)《GBT 8568-2013铁路行车组织词汇》.pptx VIP
- CRH380B动车组司机台设备及操作上课讲义.ppt VIP
- 2026《W市希望高级中学教学楼工程工程量清单编制及招标控制价计价》10000字.docx
- CRH380A型动车组-司机室讲义.pdf VIP
原创力文档

文档评论(0)