CANNED CYCLE课件.pptVIP

APPENDIX CANNED CYCLE（固定循环指令） Explanations A canned cycle consists of a sequence of six operation (Fig.) Operation 1 Position of axes X and Y Operation 2 Rapid traverse up to point R level Operation 3 Hole machining Operation 4 Operation at the bottom of a hole Operation 5 Retraction to point R level Operation 6 Rapid traverse up to the initial Point Travel distance along the drilling axis G90/G91 Cancel To cancel a canned cycle ,use G80 or a Group 01 G code. Group 01 G codes G00: Position (rapid traverse) G01: Linear interpolation G02: Circular interpolation (CW) G03