18Standardsrelatedtosurfacepreparationandtesting..docVIP

Standards related to surface preparation and testing. Table of content Section Title Page 18.1 ISO Standards 18.2 18.2 ASTM Standards 18.7 18.3 BS Standards 18.8 18.4 DIN Standards 18.9 18.5 NACE Standards 18.9 18.6 SSPC Standards 18.9 18.7 Standards from other Standardisation organisations 18.9 18. Standards related to surface preparation and testing. There are many standards relating surface painting and testing available. The most important Institutes of standardisation are: ISO International Organisation for Standardisation ASTM American Society for Testing and Materials BS British Standards DIN Deutches Institute fur Nurmung NACE National Association of Corrosion Engineers Below, the most important standards relating surface preparation are listed. They are grouped according to the issuing organisation 18.1. ISO Standards ISO 1515 Determination of volatile and non-volatile matter ISO 1517 Surface-drying test - Ballotini method ISO 1520 Cupping test ISO 1522 Pendulum damping test ISO 1573 Determination of flash point - Closed cup equilibrium method ISO 1524 Determination of fineness of grind ISO 2409 Cross-cut test ISO 2431 Determination of flow time by use of flow cups ISO 2408 Determination of film thickness ISO 2808 Determination of film thickness (WFT and DFT) ISO 2810 Notes for guidance on the conduct of natural weathering tests ISO 2811 Determination of density ISO 2813 Measurement of specular gloss of non-metallic paint films at 20o, 60o and 85o ISO 2814 Comparison of contrast ratio (hiding power) of paints of the same type of colour ISO 2815 Buchholz indentation test ISO 3679 Determination of flashpoint - Rapid equilibrium method ISO 4624 Pull-off test for adhesion ISO 4628 (1-6) Evaluation of degradation of paint coatings - Designation of intensity, quantity and size of common types of defect ISO 6270 Determination of resistance to humidity (continuous condensation)