Openfiler安装aoe,dhcp,tftp支持xp利用gpxe从san启动。.docVIP

Openfiler安装aoe，dhcp，tftp支持xp利用gpxe从san启动。 Openfiler本身不支持aoe，dhcp和tftp，这些需要安装和编译。具体过程如下： 安装openfiler 升级组件主要是支持GCC编译，列表如下 conary update gcc conary update libtool conary update glib conary update glib:devel conary update glibc conary update glibc:devel conary update automake conary update autoconf conary update pkgconfig 升级完毕。安装DHCP和TFTP-SERVER  下载安装aoe Target端主机需下载「vblade」软件来编译使用 ， 下载网址/projects/aoetools/ /sourceforge/aoetools/vblade-18.tgz 下载后解压 tar zxvf vblade-18.tgz make make install 到此软件安装完成AOE，DHCP和TFTP SERVER。 xp的安装和配置（转自/wiki/sanboot） Windows XP boot from SAN Windows XP supports booting from an AoE SAN. You cannot install directly to the SAN target; you must first install Windows XP to a physical disk. Installation Start by installing Windows XP to a physical disk. It is best to use an external USB, FireWire, or eSATA disk; this will make later stages easier. When installing, use a small partition (around 4GB) rather than the whole disk. At the partitioning screen: press C to create a partition and enter 4096 as the size (in MB). You should then see a screen that looks like: You can now press Enter to install Windows XP to this partition. The rest of the installation will proceed as normal. Preparation for SAN boot Installing the AoE initiator You need to download and install the Windows AoE initiator (WinAoE). Download the latest WinAoE package from / and extract the contents of the .zip file to a temporary directory. Start up the Add Hardware Wizard (Start → Control Panel → Add Hardware) and proceed to the “Is the hardware connected?” screen: Click on “Yes, I have already connected the hardware”, then click on Next. Scroll down to the bottom of the list and choose “Add a new hardware device”, then click on Next. Click on “Install the hardware that I manually select from a list (Advanced)”, then click on Next. Choose “SCSI and RAID controllers”, then click on Next. Click on “Have Disk…”. Click on “Browse…”. Browse to