CICS命令参考.docVIP

CICS/TXSeries安装说明 1. 有关CICS的系统软件安装 1.1 C环境, ifor C环境: 先安装bos.adt.* 设置指令：/usr/ibmcxx/bin/replaceCSET ifor: (安装在/var/ifor下)(可能要修改/etc/inittab重启动) i4cfg –stop i4cfg进入，选择第二个选项:NodeLock Server，退出时选择保存 i4cfg -start(启动) i4blt 选菜单: product/enroll-import:/usr/ibmcxx/*-cxx36_cn.lic (Ｃ++与CICS冲突时，将/etc/rc.ncs文件中 “startsrc -s glbd” 注释掉；这样，CICS可用，Ｃ++不能用。) chmod -R 777 /var/ifor 1.2 DB, SDK 1.3 系统参数(建议适当扩大) [AIX]: 系统语言环境为en_US 检查网络配置：hostname, smitty tcpip, vi /etc/hosts 修改AIX的cics用户的限制数值(在/etc/security/limits文件) fsize = -1 fsize_hard = -1 core = -1 cpu = -1 data = -1 rss = -1 stack = -1 nofiles = -1 #注：可以使用命令 chuser “nofiles=3000” cics [Solaris]: TXSeries需要的系统参数(修改/etc/system文件，需要重新启动)：设置单进程的共享内存最大为50M (参考RegionPool和TaskSharedPool的设置) set shmsys:shminfo_shmmax 设置单进程句柄硬限制为(软限制例：“ulimit -n 1024”) set rlim_fd_max = 8192 set rlim_fd_cur = 4096 CTG需要的系统参数： set msgsys:msginfo_msgmax = 65535 Maximum size of System V message. set msgsys:msginfo_msgmnb = 65535 Maximum number of bytes that can be on any one message queue. set msgsys:msginfo_msgssz = 32 Specifies size of chunks system uses to manage space for message buffers. Obsolete since the Solaris 8 release. set msgsys:msginfo_msgseg = 16384 Number of msginfo_msgssz segments the system uses as a pool for available message memory. Total memory available for messages is msginfo_msgseg * msginfo_msgssz. Obsolete since the Solaris 8 release. set semsys:seminfo_semmni = 4096 Maximum number of semaphore identifiers. set msgsys:msginfo_msgtql = 10000 The maximum number of queue entries that can be in the system at the same time. A low value can adversely affect system performance, or cause the client to freeze. IBM recommends that you set this value to the maximum (10000), or at least double the maximum number of concurrent requests. Stress load your system, and then use the ipcs -qa command to determine the set