titleovertauditsofnorthcarolinacertifiedinspection.docVIP

Title: North Carolina State Safety Inspection Procedures Lesson Purpose: To present a standardized method of testing and evaluating the performance and knowledge of Inspector- Mechanics conducting North Carolina State Safety Inspections. Student Performance Objectives: At the end of this block of instruction, the student will be able to achieve the following objectives in accordance with the information received during the instructional period. List the nine inspection areas inspector mechanics must check during a safety inspection. Identify eight emission control devices installed by vehicle manufacturers. Determine what emissions control devices are required on a vehicle by using the Emission Control System Applications Manual. Calibrate and utilize a headlight aimer. Calibrate and utilize a window tint meter. Utilizing the safety inspection regulation manual the student shall be able to successfully complete a North Carolina State Safety Inspection. Achieve a score of 80% or higher on a Division approved written exam. Hours: Eight (8) Instructional Method: Lecture / demonstration / practical exercise Classroom Environment: Academic classroom/automotive service bay Materials required: Pen/pencil Note paper Lesson outline Safety Inspection/Emission Inspection Regulations Emission Control System Application Manual Training Aids: PowerPoint Presentation Approved light testing device Approve tint meter Emission Control Manual Safety Inspection Regulations Manual References: North Carolina General Statute, Chapter 20 North Carolina Administrative Code, 19A Study Assignment: None Prepared By: D. V. Bradley Assistant Supervisor Headquarters NCDMV License and Theft Bureau B. Cross Assistant District Supervisor District III NCDMV License and theft Bureau T. I. Hickman