金枪鱼TCN124P-M012-GY03轴系安装工艺(含主机定位).docVIP

1.概述： General: 1.1本工艺描述了57000DWT散货船轴系各主要部件安装以及主机定位的技术要求。 This procedure described the technical requirement of shaft components installation and M/E locating of 57000DWT BC. 1.2轴系主要部件包含有，4叶定距螺旋桨一支（直径6000mm，重约16,347kg）,螺旋桨轴1根（φ500×6505，10211kg），中间轴1根（φ420×6006，7159kg），艉管装置1套(3839kg)，中间轴承一套（645kg）,艉轴首尾密封装置，轴接地装置一套。 Main components of shaft include the following parts, one fixed pitch propeller with four blades (diameter 6000mm, weight 16,347kg), one propeller shaft(φ500×6505，10211kg), one intermediate shaft(φ420×6006，7159kg), stern tube unit one set(3839kg), intermediate shaft bearing one set(645kg), fore and aft. shaft seal assembly, shaft grounding unit. 1.3轴系的安装工艺流程 Shaft system Installation sequence 拉线→（照光）→艉管定位浇注环氧→主机底角螺栓孔定位→装螺旋桨轴→装艏艉轴密封装置→安装无键螺旋桨→安放中间轴、主机。船下水后按轴系校中计算法定位轴系及主机。 Pulling wire→（Shaft sight）→Locating stern tube and chock fast→Locating M/E holding down bolts→Install propeller shaft→Install shaft seal assembly→Install propeller→Put intermediate shaft and M/E. After vessel launching install and connect the shaft and M/E according to the shaft alignment calculation. 注：船下水时，轴和主机作临时固定，防止螺旋桨轴转动。具体见“下水封桨封舵工艺”。 Note: Before launching fix the shaft and M/E temporarily, avoid turning of propeller shaft. Detail see “Procedure for fix rudder and propeller during launching”. 1.4所有轴系零件均为外购成品，尺寸加工到位，在吊运、安装过程中要注意保护。在进行吊装前应仔细检查吊运工具，如吊索、眼板、卸扣等应安全可靠。 All the components of shaft is finished production, please pay more attention during hoisting and installation. Check carefully handling tool before shaft hoist, such as halyard,eye plate, shackle should be safe and reliable. 2.适用范围: Range of application: 本工艺适用与12#57000DWT散货船轴系安装及主机定位施工。 This procedure is to be applied for instruct the shaft installation and M/E locating for 12# 57000DWT bulk carrier. 3.参考资料: Reference documents: SC4439(ZS)G3-400-04 机舱布置图SC4439(ZS)G3-425-01 推进轴系布置图 Shaft arrangement drawing SC4439(ZS)G3-230-02 舵系布置图 Rudder arrangement drawing SC4439(ZS