流化床锅炉冷渣机 济东电厂初设及循环流化床冷渣器设计_图文.docVIP

流化床锅炉冷渣机 济东电厂初设及循环流化床冷渣器设计_图文 导读：就爱阅读网友为您分享以下“济东电厂初设及循环流化床冷渣器设计_图文”的资讯，希望对您有所帮助，感谢您对92的支持! The ash outlet at the FBAC overflow is designed with a solid mass flow density of approximately 10 kg/m2s. The height of the FBAC overflow outlet is the same as that of the weir between the first and second chambers. The freeboard height is 1000 mm and the gas velocity in the freeboard towards the overflow does not exceed 3 m/s so as to suppress the entrainment of fine particles. Typically, the gas return duct located at the FBAC overflow is designed with a gas velocity of approximately 12 m/s. The return duct enters the lower furnace at a height of 5 m above the nozzle grid and with an inclination of approximately 25°. In the section of the return duct that leads into the furnace, the velocity is increased to 25 m/s to improve penetration into the furnace. The duct can be made of heat resistant steel or be refractory lined. The elbow is lined with abrasive resistant material. The pressure drop of the FBAC fluidization nozzles is 400 mmH2O under the design conditions as in Section 4.1, and the pressure drop in the fluidized bed is considered, the pressure in the wind box should be 2600 mmH2O. To maintain an equal nozzle pressure drop over the FBAC area, different nozzles for the different fluidization zones are required, as for the Air Distributor Ⅱ. Fig.16. Bottom ash PSD. 6. Conclusions 1) With an increase in air flow, the conveying ash flow and air pressure in each wind box increases. However, after the air flow reaches a ce