S7PLC时间继电器..docVIP

得电延时闭合，持续至“S”端为0，或“R”端复位。 If the signal state of I0.0 changes from 0 to 1 (positive edge in RLO), the timer T5 will be started. The timer runs without regard to a signal change at I0.0 from 1 to 0. If the signal state at I0.0 changes from 0 to 1 before the timer has expired, the timer will be re-triggered. The output Q4.0 will be 1 if the timer elapsed. (If the signal state of input I0.1 changes from 0 to 1, the time will be reset irrespective of the RLO at S.) 得电延时闭合，或“R”端复位。 得电闭合，延时打开，或“R”端复位。 得电闭合，延时打开，或至“S”端为0，或“R”端复位。 If the signal state of I0.0 changes from 1 to 0, the timer is started. Q4.0 is 1 when I0.0 is 1 or the timer is running. (if the signal state at I0.1 changes from 0 to 1 while the time is running, the timer is reset). 得电闭和，失电延时打开， If the signal state of input I0.0 changes from 0 to 1 (positive edge in RLO), the timer T5 is started. The timer continues to run with the specified time of two seconds as long as the signal state of input I0.0 is 1. If the signal state of input I0.0 changes from 1 to 0 before the specified time has elapsed, the timer stops. The signal state of output Q4.0 is 1 as long as the timer is running. A signal state change from 0 to 1 at input I0.1 will reset timer T5 which stops the timer and clears the remaining portion of the time value to 0. 得电闭合，延时打开，或至“S”端为0，或“R”端复位。 If the signal state of input I0.0 changes from 0 to 1 (positive edge in RLO), the timer T5 is started. The timer continues to run without regard to a negative edge of the RLO. If the signal state of I0.0 changes from 0 to 1 before the timer has expired, the timer is re-triggered. The signal state of output Q4.0 is 1 as long as the timer is running. A signal state change from 0 to 1 at input I0.1 will reset timer T5 which stops the timer and clears the remaining portion of the time value to 0. 得电闭合，延时打开，或“R”端复位。 If the signal state of input I0.0 changes from 0 to 1 (positive edge in RLO), the