VegaPrime中的海洋模块..docVIP

Vega Prime中的海洋模块 Model period Set the time, in seconds, that corresponds to the peak of the wave spectrum (i.e., the number of seconds between crests at the peak angular frequency). The Spectral Ocean Wave Model (SOWM) is a hindcast mathematical model that accounts for modal period, as well as wind speed and significant wave height, in its characterization of sea states. This function sets the surface wind speed and significant wave height that, according to the SOWM, correspond to the current modal period. 设置时间,以秒为单位,相对应的峰值的波谱(即。,波峰之间的秒数在峰角频率)。光谱海浪模型(SOWM)是一个追算数学模型,占模态周期,以及风速和有效波高,在其表征的海洋国家。这个函数设置表面风速和有效波高,根据SOWM,对应于当前模态周期。 设置时间,以秒为单位,相对应的峰值的波谱(即。,波峰之间的秒数在峰角频率)。光谱海浪模型(SOWM)是一个追算数学模型,占模态周期,以及风速和有效波高,在其表征的海洋国家。这个函数设置表面风速和有效波高,根据SOWM,对应于当前模态周期。 surface wind speed Set the velocity of the wind in knots. While it is set in knots, it is stored in meters per second, and is considered constant over the entire ocean. Anemometers measure wind speed at either 10 or 19.5 meters above sea level, which is why this wind speed is distinguished from the wind speed in Vega Prime?s environment. Parameters: fWindSpeedInKnots? The surface wind speed, in knots. This value must be positive. The default is 15 knots. Returns:vsgu::SUCCESS if successful, vsgu::FAILURE otherwise. 设置速度的风在海里。当它被设置在海里,它存储在米每秒,和被认为是常数在整个海洋。 风速计测量风速在要么10或海拔19.5米,这就是为什么这个风速区别于风速在织女星主要?年代环境。 参数:fWindSpeedInKnots 表面风速,在海里。这个值必须是积极的。默认是15节。 返回: vsgu::成功如果成功,vsgu::失败否则。 Significant Wave Height Set the height of the average of the highest one third of all waves. This should be a positive number, specified in meters. The default is 1.0. Parameters: fSignificantWaveHeightInMeters? The vertical distance, in meters, from the crest to the trough of the wave. Returns: vsgu::SUCCESS if successful, vsgu::FAILURE otherwise. 组的平均身高最高的三分之一的电波。这应该是一个正数,指定在米。默认值是1.0。 参数:fSignificantWaveHeightInMeters 垂直距离,在米,从波峰到波谷的波。 返回:vsgu::成功如果成功,vsgu::失败否则。 Dominant Wave Direction Set the direction angle that th