n a t i o n a l c e r t i f i c a t i o n e x a m i n a t i o n- e m e a（n t i o n l c e r t i f i c t i o n e x m i n t i o n - e猴e）.docVIP

Model Question Paper-2006 NATIONAL CERTIFICATION EXAMINATION FOR ENERGY MANAGERS ENERGY AUDITORS PAPER – 2: Energy Efficiency in Thermal Utilities Duration: 3 HRS Max. Marks: 150 Section – I: OBJECTIVE TYPE Marks: 50 x 1 = 50 (i) Answer all 50 questions (ii) Each question carries one mark (iii) Put a (() tick mark in the appropriate box in the answer book 1. Which of the following fuel needs preheating for pumping from storage tank a) LSHS b) Furnace Oil c) Heavy Fuel Stock d) All of the above 2. Pour point of the fuel is the ……. a) Lowest temperature at which it will flow when cooled from high temperature b) High temperature at which it will flow when heated from low temperature c) Lowest temperature at which it will solidify when cooled from high temperature d) Highest temperature at which it will solidify when cooled from high temperature 3. Sulfur content is lowest in a) LSHS b)LDO c) Furnace oil d) Kerosene 4. Calorific value of fuel is highest in Furnace oil b) LSHS c) LDO d) Anthracite coal 5. Spontaneous combustion can be prevented by a) Allowing more ventilation of air b) Spraying water over the leaps of coal c) Both a and b d None of the above 6. Higher the sulphor content in the fuel, Dew point temperature will a) decrease b) increase c) same d) No impact 7. Which of the following is recommended for pumping light fuel oil a) Diaphragm Pump b) Gear Pump c) Centrifugal Pump d) All of the above 8. High ash content will a) Increase the handling cost b) Causes clinkering and Slagging c) Reduces boiler capacity d) All of the above 9. Blending of coal means a) Mixing of excessive fines with large lumps of coal b) High GCV coal with Low GCV coal c) Both a and b d) Mixing high sulphor content with low sulphor content 10. Moisture con