ppt课件-asimpleunitcommitmentproblem-economics.pptVIP

A SimpleUnit Commitment Problem Valentín Petrov, James Nicolaisen 18 / Oct / 1999 NSF meeting Economic Dispatch (Covered last time) With a given set of units running, how of the load much should be generated at each to cover the load and losses? This is the question of Economic dispatch. The solution is for the current state of the network and does not typically consider future time periods. Deciding which units to “commit” When should the generating units (G) controlled by the GENCO be run for most economic operation? Concern must be given to environmental effects How does one define “economic operation”? Profit maximizing? Cost minimizing? Depends on the market you’re in. Problem Setup Last meeting we discussed the economic dispatch problem Now we will see how the unit commitment fits into the general picture Unit commitment is bound to the economic dispatch Use similar optimization methods What is Unit Commitment (1) We have a few generators (units) Also we have some forecasted load Besides the cost of running the units we have additional costs and constraints start-up cost shut-down cost spinning reserve ramp-up time... and more What is Unit Commitment (2) It turns out that we cannot just flip the switch of certain units on and use them! We need to think ahead, and based on the forecasted load and unit constraints, determine which units to turn on (commit) and which ones to keep down Minimize cost, cheap units play first Expensive ones run only when demand is high How Do We Solve the Problem If a unit is on, we designate this with 1 and respectively, the off unit is 0 So, somehow we decide that for the next hour we will have 0 1 1 0 1 if we have five units Based on that, we solve the economic dispatch problem for unit 2, 3 and 5 We start turning on U2, U3, U5 When the next hour comes, we have them up and running To Come Up With Unit Commitment The question is, _how_ do we come up with this unit commitment 0 1 1 0 1 ? One very simplistic way: if we have ver