specificationsforhighdensitypolyethylenegeomembrane（30页）.docVIP

Drop-In Specifications Standard Geomembranes (Metric Units) The following drop-in specifications is a sample guideline to be customized by the engineer for preparing site specific specification. This information is provided for reference purposes only and is not intended as a warranty or guarantee. GSE assumes no liability in connection with the use of this information. Please contact GSE for current specifications. GENERAL SCOPE This drop-in specification covers the technical requirements for the Manufacturing and Installation of the geomembrane. All materials meet or exceed the requirements of this specification, and all work will be performed in accordance with the procedures provided in these project specifications 1.2 REFERENCES A. American Society for Testing and Materials (ASTM) 1. D 1004 Test Method for Initial Tear Resistance of Plastic Film and Sheeting 2. D 1238 Standard Test Method for Flow Rates of Thermoplastics by Extrusion Plastometer 3. D 1505 Test Method for Density of Plastics by the Density-Gradient Technique 4. D 1603 Test Method for Carbon Black in Olefin Plastics 5. D 3895 Standard Test Method for Oxidative-Induction Time of Polyolefins by Differential Scanning Calorimetry 6. D 4218 Standard Test Method for Determination of Carbon Black in Polyethylene Compounds 7. D 4833 Standard Test Method for Index Puncture Resistance of Geotextiles, Geomembranes, and Related Products 8. D 5199 Standard Test Method for Measuring Nominal Thickness of Geotextiles and Geomembranes 9. D 5397 Standard Test Method for Evaluation of Stress Crack Resistance of Polyolefin Geomembranes Using Notched Constant Tensile Load Test 10. D 5596 Standard Test Method for Microscopic Evaluation of the Dispersion of Carbon Black in Polyolefin Geosynthetics 11. D 5994 Standard Test Method for Measuring Core Thic