technicalspecificationforroadworks（13页）.docVIP

P-1 Technical specification FOR Road works 1.0 GENERAL 1.01 The specifications and mode of measurements for all the works mentioned in this tender shall be in accordance with C.P.W.D specifications 1996 volumes I to VI. Unless otherwise specified in the nomenclature of individual item or in the specifications, the entire work shall be carried out as per the C.P.W.D specification with upto date correction slips upto the date of opening of tender. 1.02 For Items not covered under CPWD specifications mentioned above, the work shall be executed as per “Specifications for Road Bridge Work” published by Ministry of surface transport, “Hill Road Manual” (IRC:SP:48-1998) published by the Indian Road Congress, and as per relevant standards/codes published by BIS (formerly ISI) inclusive of all amendments issued thereto or revision thereof, if any, upto the date of opening Tender. 1.03 In case of BIS (formerly I.S.I) codes/specifications are not available, the decision of the Engineer based on acceptable sound engineering practice and local usage shall be final and binding on the contractor. 1.04 However, in the event of any discrepancy in the description of any item as given in the schedule of quantities or specifications appended with the tender and the specifications relating to the relevant item as per CPWD specifications mentioned above or in drawings the former shall prevail. 1.05 The rates for different items of work shall be for all heights, lifts, leads and depths except where otherwise specified in the item of work or in additional conditions appended with the tender. 1.06 The work shall be carried out in accordance with the approved drawings. The drawings shall have to be properly co-related before executing the work. In case of any difference noticed between the drawings, final decision, in writing of the Engineer shall be obtained by the contractor. For items, where so required, samples shall be prepared before starting the particular items