ppt课件-e p g synchrophasor solutions（e p g synchrophasor解决方案）.pptVIP

* The typical system sends data from the PMU to the PDC, and then the PDC to applications. Each data link needs to be calculated based on these requirements. These data rates are bytes/sec. Communication is usually calculated in bits/sec, so a simple way to estimate that requirement is multiply all the numbers by 10. Give examples. In the WECC, we use a 30 sample/sec data rate, so these are highlighted in the charts. PMUs are typically set for 5-10 phasors per unit, with 5 or 10 the most common. The PDC output is always on Ethernet because the PDCs we are using only outputs via Ethernet