The optimization of laying the solar PV.docVIP

The optimization of laying the solar PV 　　Abstract. At present， the biggest problem people are faced with is the issue of the energy and resources， so the use of the renewable energy has become the development-based strategy of the energy around the world. Therefore， the solar photovoltaic system is divided into two： the networking photovoltaic system and the independent photovoltaic system， both of which have a rapid development in recent years， while the independent photovoltaic system is mainly used as the photovoltaic cells. This paper briefly introduces the application of the solar photovoltaic battery system. 　　Key words： Solar photovoltaic battery； photovoltaic system； photovoltaic building integration； photovoltaic lighting 　　1. Introduction 　　Solar photovoltaic power generation system is composed of four basic structures of the panel， the inverter， the controller and the battery. The use of the photoelectric system should analyze first the solar energy structures， and now the photoelectric system is developing rapidly in China， so we need to use the value of the photoelectric system， and do the multi-cost recovery. Secondly， we should briefly analyze the structure of the solar photovoltaic cells. The solar photovoltaic development should start from three aspects of the development cost， the running efficiency， and the reliability， to improve the technical efficiency with specific analysis and discussion. If we want to optimize the solar photovoltaic system we need to further design and analyze this structure， and we need to optimize the representative appliances， and compare both the optimization and the inverter. Finally， we come to the conclusion and summarize the design to propose the topology structure of the main circuit of double boosted by the former stage voltage matching and the post stage full bridge inverter. Since then， through the effective analysis of the efficiency of the solar power system in Tianjin， we also verified the design of p