w8 u m s t a t i o n e q u i p m e n t d o c u m e n t a t i o n（w8 u m s q t t i o n e u i p m e n t d o c u m e n t t i o n）.docVIP

下载本文档

9
0
约1.52万字
约 10页
2017-01-24 发布于四川
举报
版权申诉

w8 u m s t a t i o n e q u i p m e n t d o c u m e n t a t i o n（w8 u m s q t t i o n e u i p m e n t d o c u m e n t t i o n）.doc

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

W8UM STATION EQUIPMENT DOCUMENTATION AMP-HF-SB-220 Equipment: Heathkit SB-220 HF Amplifier Scope: Description, Operation, History Date: 12/27/2006 Author: C. Galbraith KA8WFC Contact: cgalbrai@umich.edu, (734) 678-2779 INTRODUCTION: Please read this entire document once before using the SB-220 for the first time and make sure that you understand all of the procedures. For more information on operation, theory, and servicing, please see the Heathkit SB-220 factory manual and related notes in the W8UM equipment document files. DESCRIPTION: The Heathkit SB-220 is a vacuum tube triode-based radio-frequency (RF) linear amplifier for the 80m through 10m (3.5 MHz through 29.7 MHz) amateur radio bands. The amplifier requires careful operation to ensure its safe use. Each time the amplifier is used, it must be properly tuned using the front-panel controls. Using this amplifier without proper training will result in damage to the amplifier and other W8UM station components. The amplifier has two power settings—CW/TUNE (low power) and SSB (high power). It is rated for a DC input power of 1 kW in the CW/TUNE position or 2 kW peak envelope power (PEP) in the SSB position. The amplifier nominally gives 550-650 W of useful output power on CW and 1000-1100 W of useful output power on SSB, at frequencies up to about 21.5 MHz. Above 21.5 MHz, power output will be 400-500 W (CW/TUNE) and 750-900 W (SSB). On high duty cycle modes such as CW, RTTY, and PSK, the low power setting must always be used. The high power setting should only be used for SSB and only when absolutely necessary—the 3 dB increase (600 W versus 1200 W) in transmitted signal level in the high power setting results in increased strain on the amplifier tubes, power supply, and output network components, as well as the rest of the system (balun, antenna tuner, etc.) While 3 dB may seem like a lot, it is only “just perceptible” to a human and causes an increase of only 1/2 of an S-unit at th