论文规范格式..docVIP

河北联合大学轻工学院 设计说明书 高精度弯管流量计设计(题目) 学 院：轻 工 学 院 学生姓名：胡韶奕 曹硕 刘帅 指导教师：王晓禹 邱常明 设计说明 时间：二零一二年8月1日~10月10日 共10周 扉页 扉页内容一般包括论文题目、作者、单位、指导教师、论文提交日期等，可以采用中英文对照编排。摘要 弯管流量计一种新型流量计，它利用管道上直角拐弯处的弯管，测量弯管内、外侧压力，计算得到流量。弯管流量计具有优点如、能脏污、无附加损失等， 现在市场上的弯管流量计，有着诸多不如意的地方。首先， 45°方向取压，对于小流量不敏感，导致测量精度严重降低；其次，机加工弯管传感器的横剖式生产影响取压孔处流体流动状态，造成差压值不稳定和测量精度的降低；第三，现场管道规格的多种多样，对弯管流量计的备货和安装造成困难。 为解决上述问题，本文从弯管流量计的原理出发，弯管内部流体流动状态进行理论分析，得到弯管内部流体流动状态的变化压力 在机加工弯管传感器的加工方法上，开发了全新的加工方式，解决了结合面对取压造成影响这一难题。本文介绍了弯管传感器的生产过程就生产过程中出现的难点问题进行了探讨，给出。 关键词：弯管流量计；； 摘 要 论文摘要是学位论文的缩影，文字要简练、明确。内容要包括目的、方法、结果和结论。 摘要格式说明： 摘要正文后，列出3-个关键词。关键词请尽量用《汉语主题词表》等词表提供的规范词。 关键词与摘要之间空一行。关键词间用号间隔，不加标点，3-个，，小四。 Abstract The elbow flowmeter is a kind of new flowmeter. It was the elbow of the right angle bend on pipeline to meter the inside and outside of the elbow of the right angle. According to this pressure difference, we can count out the rate of flow. The elbow flowmeter has some prominent advantages, such as free maintenance, long lifetime, measurement of ditty medium, no additional resistance loss, so it is a typical environment protection flowmeter. Now, the elbow flowmeter on the market have too many disadvantage. First, they drop the accuracy of measurement, because these elbow flowmeter take pressure by 45°, which is not sensitive with swan flow. Second, the cross profile of machinery elbow flowmeter transducer has some bad influence on the status of the pressure hole at the fluid flow, which will cause the differential pressure value unstable and decline the measuring accuracy. Furtherer more, it is difficult to stock and install the elbow flowmeter because the pipeline specifications are variety. In order to solve the above problems, this article starts from the principle of the elbow flowmeter, and uses the Flow simulation----Fluid analysis module to analysis the theory of the inside fluid statement of bend sensor. Then, we can get the diversification and pressure d