19series-safetyvalve-apollovalves.docVIP

19SERIES-SAFETYVALVE INSTALLATION, OPERATION, MAINTENANCE Part I Document Number: ES-1045-1 Revision Level: H Issued By: T.HAMILTON Date: 3/3/16 Approved By: Date: Conbraco Industries, Inc. P.O. Box 247 Matthews, NC 28106 (704) 841-6000 Fax (704) 841-6020  Table of Contents Maximum Pressure/Temperature Chart2 Installation Instructions3 Operating Instructions3 Maintenance and Testing Instructions4 19 Series Part Number Matrix4 Nameplate Information 5 Amendment Register 6 IMPORTANT Conbraco pressure relief valves are safety devices designed for the protection of lives and property. These valves will provide years of service when properly installed and maintained. The information contained herein is intended for use by qualified personnel to properly maintain these devices. Serious property damage and injury or death may occur should a pressure relieving device fail to operate correctly. Any installation, maintenance, adjustment, repair or testing should only be performed by experienced personnel properly trained and qualified in accordance with applicable codes and standards. When maintaining or repairing Conbraco pressure relief valves, use only original Conbraco parts to ensure safe and reliable operation. Contact your local Conbraco factory representative for the name of a factory authorized repair center near you. Or visit us on the web at . Maximum Pressure/Temperature Chart Warning – Application must not exceed the pressure/temperature limitations below. Series 19K 19M 19L 19S Trim Seat Brass PFA Teflon? Brass Metal to Metal Stainless Steel PFA Teflon? Stainless Steel Metal to Metal Max. Set – Steam 250 psi (1723.7 kPa) 250 psi (1723.7 kPa) 250 psi (1723.7 kPa) 300 psi (2068.4 kPa) Max. Set – Air/Gas 300 psi (2068.4 kPa) 300 psi (2068.4 kPa) 300 psi (2068.4 kPa) 300 psi (2068.4 kPa) Max. Temperature 406oF (207.8oC) 406oF (207.8oC) 406oF (207.8oC) 422oF (216.7oC) ES1045-1, IOM, 19 Series Rev. H 2  Installation Instructions This quality Conbraco saf