SD的安装演示文件修改版.pptVIP

SmartDate 5的安装 目标 教程 SmartDate 5支架选择 SmartDate 5支架选择 马肯提供四种标准支架 Window Bracket Solid End-Plate Bracket ‘L’ Bracket Labeller Bracket SmartDate 5支架选择 调节辊 对于间歇式应用,可以以此调节打印位置 对于连续式应用,可以用来避开衬底每次拉袋时速度的突变阶段 调节辊需安装在打码机后面 立式包装机VFFS (Vertical, Form, Fill, Seal) 调节辊 连续式L型支架 发现过如图:因侧面电缆接头妨碍了安装 Fitting the SD5 on to existing L brackets in the field or onto any of the other continuous L bracket options supplied in 2005, could result in the SD5c body interfering with the front/rear side plate or the cassette removal being obstructed by the side plate. This is noticeable when printing near to the edge of the film or on applications where the width of the bracket is very narrow SmartDate 5 连续式L型支架 Original SD2c 3c installations of the Continuous L bracket 5824513 installed before end Dec 2005 Use head mount assembly 5825194 - for retrofitting SD5c to the above bracket in the field Continuous L bracket 5825195 (intended for SD2,3 5) THIS IS NOW OBSOLETE SD 5 has cassette restrictions with original brackets 5824513 5825195, if the printer is mounted near to the end plates. This applies to brackets supplied before 02/01/06 Cable exist will interfere with support tubes fitted to the left hand side of an SD5 print head A revised version of bracket 5824513 is available from the EDC as of the 02/01/06 打印体安装块(除L型支架外的所有支架) The four printer mounting holes in the Printer Mounting Plate used with the Window and Solid-End-Plate Brackets are offset: They should be positioned to the right for a left handed printer, and visa-versa. 打印体安装块(除L型支架外的所有支架) A Left handed printer, showing the mounting plate positioned correctly: SmartDate 5的安装 内容: 安装的物理要求 电,气和环境需要 左右手 打码机安装点位置 物理对齐(打印头和胶辊) 同步轮 连接器 电源,输入／输出,气源 练习:安装机器到可以上电的状态 安装SmartDate 5　左右手 正确理解左右手较为重要 对于间歇式应用，增加红箭头表示打印头移动方向 在连续式的应用,衬底必须以正确的方向经过打码机(衬底方向和上面的箭头方向相反) 安装SmartDate 5　左右手 安装SmartDate 5　打印体安装孔 在机器顶部三组安装孔,用于锁支架 安装SmartDate 5 :安装对齐 安装SmartDate 5 :安装对齐 安装SmartDate 5 :安装