1001 Torque (TRU公司玩具的扭力测试标准)供参习.docVIP

QUALITY AND SAFETY ASSURANCE PROGRAM TITLE TORQUE/TENSION NUMBER QSAP-1001 DATE May 30, 2003 PREPARED BY MINA LAI APPROVED BY HOPE DEBLASIS REVIEWED BY GENE GILLESPIE REVISION 1 1 SCOPE Products and Components Covered The torque and tension test is applicable on any projection that a child can grasp with at least the thumb and forefinger or teeth. Exemptions Components that protrude 0.02 inches (6mm) or less from mating surfaces, provided any gap between the protrusion and the mating surface does not exceed 0.02 inches (0.5mm). Hemispherical, cortical or elliptical protrusions, regardless of size, provided any gap between the protrusion and the mating surface does not exceed 0.02 inches (0.5mm). Fabrics and fabric seams. 2 PERFORMANCE REQUIREMENTS Safety Requirement Product must present no hazardous conditions, including, but not limited to conditions found when evaluated per: QSAP 0006-1002; Sharp Points QSAP 0006-1003; Sharp Edges 2.1.3 QSAP 0006-1004; Small Parts Criteria on torque and tension force shall refer to Appendix I. Reliability Requirement 2.2.1 Product shall retain intended function after in 4 in lbs and 15lbs test according to below test method. Exemption is allowed only during design stage on specific material and approval by Pacific Playthings. 2.2.2 Product may be expected to retain function under a higher abuse according to different product nature. Specific requirement will be stated in Engineering/ Inspection specification. 3 EQUIPMENT Equipment Clamp or adaptor that will hold test component firmly without affecting the structural integrity of the component. Torque wrench with accuracy of ± 0.2 in. lbf (± 0.02Nm) Tension gauge with accuracy of ± 0.5lb (2 N). Dead weight with accuracy of ± 0.5lb (2 N). Filler Gauge Caliper 4 TEST METHODS Preparation Perform torque test, and then tension test. Test products which are intended to be assembled by an adult, as assem