斜齿轮强度计算.ppt

Key points 1 Load on helical gear tooth from power transmitted 斜齿圆柱齿轮传动的受力分析 1 Load on helical gear tooth from power transmitted 斜齿圆柱齿轮传动的受力分析 2 Contact fatigue strength of helical gear tooth 斜齿圆柱齿轮传动的接触疲劳强度 THANKS FOR LISTENING * * Dr. Liu Wenping liuwp@sdu.edu.cn 8839 2850 Chapter 12 ??????? Updated 13/10/2009, Richard Design of helical gears 斜齿轮传动设计 Force analysis of helical gears 斜齿轮的受力分析 Strength calculation of helical gears 齿轮强度计算公式: 应用注意事项、参数意义 Fn1 in the normal plane(法面) Pabc can be decomposed into 3 components: Ft1, Fr1 and Fa1 Relationship: Direction of forces 各力的方向判断 Fr, Ft: the same as those of spur gears Fa: Left- and Right-hand rules (左、右手定则) for driving gear Presentation of forces: 表示方法 Right-handed Left-handed Driving gear n1 n2 driving Fr2 Fr1 Ft2 Ft1 Fa1 Fa2 Amendments to the parameters: 1) Length of contact line L 接触线长度L x：接触线总长度变化系数(0.9~1)； Zε：重合度系数 若ε?1, 则取ε?=1 2) Helix angle factor Z? 螺旋角系数 Amendments to the parameters: Increasing helix angle ? is good for gear tooth meshing action; this is beneficial for reducing the contact stress because the length of contact line becomes longer, and for decreasing shock load and vibration and noise. Amendments to the parameters: 3) Curvature radius at the contact point 接触点曲率半径 --spur gear --helical gear Curvature radius of helical gear increases and the contact stress decreases accordingly P222 图12.16, 按螺旋角查取ZH Calculation formula for contact fatigue strength 接触疲劳强度的计算公式 Notes for the above formula: Contact strength check 接触疲劳强度校核公式 Design formula 接触疲劳强度设计公式 How to use? 与直齿相同 据β查Ad，由材料系数修正 P226 3 Bending fatigue strength of helical gear tooth斜齿轮弯曲疲劳强度 潘存云教授研制 潘存云教授研制 斜齿轮齿面上的接触线为一斜线。 轮齿的失效形式: ?局部折断 Bending strength check弯曲强度校核公式 Design formula 弯曲强度设计公式 2)YFa and YSa—can be obtained from P229-230 3)Yβ —helix angle factor 螺旋角系数 Compared with spur gears: 1) mn see P239 Compared with spur gears: 4)Yε