51单片机编码.doc

#includereg52.h #includeintrins.h #define uchar unsigned char #define uint unsigned int #define LCDIO P0 sbit rs=P2^0; sbit rd=P2^1; sbit lcden=P2^2; sbit acc0=ACC^0; //移位时的第0位 sbit acc7=ACC^7; //移位时用的第7位 sbit ct=P2^3; sbit speaker=P3^5; int djs11=0,js,dsmin=0,dshour=0; sbit DQ=P2^5;//ds18b20与单片机连接口 uchar second,minute,hour,day,month,year,week,count=0; uchar ReadValue,num,time; uint tvalue;//温度值 uchar tflag; uchar code table[]={ 2000-00-00 FRI}; uchar code table1[]={ 00:00:00 }; uchar code table2[]= THUFRISATSUNMONTUEWES; char szdata[8]; char szdata1[8]; uchar data disdata[5]; sbit DATA=P3^3; //时钟数据接口 sbit RST=P3^4; sbit SCLK=P3^2; sbit menu=P2^7; //菜单 sbit add=P2^6; //加一 sbit dec=P2^4; sbit set=P2^3 ; //减一 sbit djs=P3^6; void miaobiao(); void yx(); void delayms(int x) //延时程序 { char i; while(x--) { for(i=150;i0;i--); } } void delay(uint z) { uint x,y; for(x=z;x0;x--) for(y=110;y0;y--); } void delay1(uint z) { for(;z0;z--); } void write_com(uchar com) //这个是让液晶屏显示数据的程序 { rs=0; rd=0; lcden=0; LCDIO=com; delay(5); lcden=1; delay(5); lcden=0; } void write_date(uchar date) { rs=1; rd=0; lcden=0; LCDIO=date; delay(5); lcden=1; delay(5); lcden=0; } void init() { uchar num; lcden=0; write_com(0x38); write_com(0x0c); write_com(0x06); write_com(0x01); write_com(0x80); delay(5); write_com(0x80); for(num=0;num15;num++) { write_date(table[num]); delay(5); } write_com(0x80+0x40); for(num=0;num15;num++) { write_date(table1[num]); delay(5); } } void Write1302(uchar dat)//时钟芯片的读取程序 { uchar i; SCLK=0; //拉低SCLK，为脉冲上升沿写入数据做好准备 delay1(2); //稍微等待，使硬件做好准备 for(i=0;i8;i++) //连续写8个二进制位数据 { DATA=dat0x01; //取出dat的第0位数据写入1302 delay(2); //稍微等待，使硬件做好准备 SCLK=1; //上升沿写入数据 delay1(2); //稍微等待，使硬件做好准备 SCLK=0; //重新拉低SCLK，形成脉冲 dat=1;