V-最新解法【DOC精选】.docVIP

V 2018 地址要求： 所有以太网接口地址，为YY.YY.0.0/27和YY.YY.128.0/27这两个网段 (接BB的接口除外) lo0 为YY.YY.x.x/24，如果有设备lo0没配，你需要手工配上 Section 1 Layer 2 Technologies The following has been pre-configured on your exam: VLAN trunk protocol (VTP) the mode is transparent and domain is CCIE PPP on the serial link b/w R2 and R3 （PPP接口已经预配有ip unnumbered，R2是借用G0/0，R3是借用G0/1） 注意，在PPP接口下千万不要打no peer neighbor-route，否则链路不通 VLAN ports assignments are per the table below: 10 Marketing R1 G0/1 11 Sales R1 G0/1 20 Engineering R2 G0/0 30 HR R3 G0/0 33 BB3 Sw3 F0/10 42 ISP42 R4 F0/0; SW2 51 ISP51 R5 F0/1 54 ISPBB R4 F0/1 ; R5 F0/0 234 Support R2 G0/1 243 QA SW2, SW3, SW4 300 Admin R3 F0/1 Troubleshooting layer 2 switching Two faults has been injected into the pre-configurations. These issues may xxxx for certain portions of the lab. You must … … Score one fault: score 2 points Score two faults: score 4 points 1、sw3 上有一个moniter session 1 目的接口指向f0/10，要去掉 No monitor session 1 2、R1上单臂路由的预配置有错 Int g0/1.11 Encapsulation dot1q 11 native--------------这个native要去掉，多余的 Provisioning a robust layer 2 core Configure the appropriate features, according to the following requirements: Deploying 802.1w on all four switches 所有交换机启用RSTPspanning-tree mode rapid-pvst Ensure that the spanning tree enters the forwarding state immediately for all the access switchports bypassing the listening and learning states. Do not change the default the configuration affecting all access switchports ( Ports connected to the backbone are not considered access ports). 启用portfasInt xxx spanning-tree portfast 以下几个接口要启用： SW1和SW2：F0/2、F0/3、F0/4、F0/5 Avoid transmitting BPDUs on any access switchport. If a BPDU is received on any of these ports, the port should be shut down immediately. Use a single command per switch to accomplish this. 这个是要求启用bpduguardspanning-tree po