专业英语Lesson6.docVIP

Lesson 6 Fractional Distillation Fractional distillation is the separation of a mixture of compounds by their boiling point, by heating to high enough temperatures. Fractional Distillation in a Laboratory Apparatus round bottom flask conical flask Liebig condenser anti-bumping granules thermometer rubber bungs (unless quick fit apparatus is used) Method As an example, consider the distillation of a mixture of ethanol and water. Ethanol boils at 78.5°C whilst water boils at 100°C. So by gently heating the mixture, the ethanol will boil off first. Some mixtures form azeotropes, where the mixture boils at a lower temperature than either component. In the ethanol example, a mixture of 95% ethanol and 5% water boils at 78.2°C, so the ethanol cannot be completely purified by distillation. The apparatus is assembled as in the diagram. The mixture is put into the round bottomed flask along with a few anti bumping granules, and the fractionating column is fitted into the top. As the mixture boils, vapor rises up the column. The vapor condenses on the glass platforms inside the column, and runs back down into the liquid below, refluxing distillate. Only the most volatile of the vapors stays in gaseous form all the way to the top. The vapor at the top of the column will be almost pure ethanol. This then passes into the condenser, which cools it down until it liquefies. The process continues until all the ethanol boils out of the mixture. This point can be recognized by the sharp rise in temperature shown on the thermometer, from the boiling point of ethanol to the boiling point of water. Industrial uses of Fractional Distillation棗nOil refinery The most important industrial application of fractional distillation is the distillation of crude oil. The process is similar in principle to the laboratory method described above except for scale, continuous feed and operation, and the fact that crude oil has many different compounds mixed together. The fractionating column