ANSYSCFX础训练课程7.pptVIP

* * Residual and Monitor plot Residual plot Monitor points CFX Solver Manager Check the Domain Imbalances at the end of the .out file for each equation You can right click in the text monitor, select Find… and search for “Domain Imbalance” to find the appropriate section An imbalance is given for the U-Mom, V-Mom, W-Mom, P-Mass and H-Energy equations It took 653 iterations to satisfy the Conservation Target of 1% for the H-Energy equation – see the Plot Monitor 1 tab Close the Solver Manager View the results in CFD-Post by double-clicking Results in the Project Schematic from the room system CFD-Post Select Location Plane from the toolbar In the Details windows on the Geometry tab, set the Definition Method to ZX Plane Set Y to 1.2 [m] On the Colour tab set Mode to Variable Set Variable to Temperature Set Range to Local and click Apply Observe the temperature distribution (for example, how the warm air collects under the table) Start by creating a ZX Plane at Y = 1.2 [m] CFD-Post ZX Plane at Y = 2 [m] ZX Plane at Y = 5.1 [m] XY Plane at Z = 0.25 [m] When finished observing the temperature distribution, uncheck the visibility boxes of the planes that you created Using the same procedure, create several other planes displaying the temperature profile: CFD-Post Click Insert Vector from the main menu In the Details windows on the Geometry tab, set Location to Plane 2 and Symbols Size to 3.0 in Symbol tab Click Apply After observing the flow behavior on Plane 2, switch the Location to Plane 4 Plot vector plots on the planes that you created: Further Steps (Optional) Observe the density variation at various planes Create a streamline from each of the vents You may want to adjust the values on the Limits tab (Max. Segments) Animate the streamlines Right-click on the Streamlines in the 3D viewer and select Animate Create an isosurface based on different temperatures (e.g., 22 [C], 24 [C], etc.) Calculate the areaAve of Wall Heat Flux on the workers Cli