模流分板模版摘要.pptVIP

Deflection Z component Shrinkage deflection 缩水量 1.67=119.25*1.4%(mm) Deflection scale 图示变形比例 1 Including Shrinkage deflection 包括缩水 3.49=(2.3+1.19)mm Excluding Shrinkage deflection 不包括缩水变形量 1.82mm Specification: 变形说明 Deflection scale factor is 1. the red color(positive number) show the deflection is to +Z axis, the blue color(negative number)show that the deflection is to –Z axis. Deflection, differential cooling(不同的冷却引起的变形)  Specification: 变形说明 It shows the deflection of differential cooling caused by all effects is 0.34mm * Deflection, differential shrinkage(不同的收缩引起的变形)  Specification: 变形说明 It shows the deflection of differential shrinkage caused by all effects is 4.9mm * * Deflection, orientation effects(分子取向引起的变形)  Specification: 变形说明 It shows the deflection of orientation caused by all effects is 1.97mm Conclusions and suggestions Changing packing profile and other injection parameters can improve the deflection. Most of the flow front temperature is always within the recommended temperature range for the polymer used, shear heating appears , please notice venting. The volumetric shrinkage distribution is uniform, Maybe there will produce the sink marks at thick areas when production. Propose to optimize the injection parameters. The main factors for deflection is Differential shrinkage and the orientation effects. Upwards ,please confirm. * Moldflow Analysis Report Project name(SGM) (项目名) HAN2050 Part name(SGM) (零件名) 大下饰板（电动） Part number(SGM) (零件号) 3VD_881_318 CAD Version (CAD模型版本) UG8.0 Date (日期) 2014.08.13 Moldflow REV (Moldflow版本) Moldflow 2012 Mould / Product Company (模具/零件供应商) 瀚氏 Moldflow Analyst (Moldflow工程师 ) Laughing xu Part Information(产品信息) Appearance Requirements (外观要求) Don’t appear obvious welding line, shrinkage mark, gas mark etc. Structural Requirements (结构要求) Lifter and slider Deflection Requirements (变形要求) According to the requirement of assembling from customer Part Volume (产品体积) 266cm^3 Nominal Wall Thickness (产品壁厚) 2.50 mm Product Ma