600MW给水泵选型研究.docVIP

600MW给水泵选型研究 毕业设计(论文)英文题目  摘要 本文探讨600MW机组给水泵的选型。通过对国内外给水泵配置方案的比较中，可以发现100%容量的汽动给水泵将是未来发展的趋势。本文研究了600MW的机组配置方案为100%容量的汽动给水泵的选型。 在选型过程中，通过对计算机软件法、型谱法和手册选型的方法介绍，再结合自己的条件，从中选取了手册法作为前置泵的选型方法。由于100%容量的汽动给水泵国内企业制造工艺达不到要求，国内600MW以上的机组采用这种配置的给水泵全是进口国外的设备。因此，本文的汽动给水泵借鉴内蒙古布连电厂的经验，直接选用该电厂同一型号的100%容量的汽动给水泵。通过以上工作，从而完成了600MW给水泵组的选型工作，为600MW机组给水泵的选型做出一份探讨和研究。 关键词：600MW；配置；100%容量；选型方法；给水泵 Abstract This paper discusses selection of feed pump in 600MW unit of power plant.By comparing the domestic and international feed water pump configuration scheme , we found that 100% capacity of turbine driven feedwater p ump will be the trend of future development.This paper studies 600MW units’ configuration solution for 100% capacity TDFP selection.In the progress of selection,given the introductions of the computer software selection method, the spectrum method and manual method,combined with their own conditions,we chose the manual method for booster pump.domestic enterprises manufacturing process of 100% capacity steam feed pump can not meet the requirements, so domestic units over 600MW which configurated this kind of feed water pump power all use imported equipment abroad . Therefore, in this paper, steam feed pump based on the experience of the Bulian power plant in Inner Mongolia,we directly select the same type ,100% capacity steam feed pump of the power plant . Through the above work, we completed the selection of 600MW feed water pump group ,and made contribution to study and research on 600MW feed water pump selection. Key Words: 600MW;allocation;100% capacity;Selection method;Feed water pump 目录 摘要 I Abstract II 目录 III 1.概论 1 2. 配置方案的确定 5 2.1 600 MW机组给水泵组主要有以下几种配置方式： 5 2.2 电动泵与汽动泵的分析 6 2.3. 汽动给水泵台数分析 6 2.3.1 经济性比较 6 2.3.2 热耗比较 6 2.3.3 投资比较( 单台机组) 7 2.3.4 运行维护费用比较 7 2.3.5 回收年限比较 8 2.4无电泵启动的安全性、经济性分析 8 2.5 结论 9 3 给水泵选型方法的确定 10 3.1 泵的计算机软件系统选型法 10 3.1.1选型软件的总体构思 10 3.1.2软件选型的特点 11 3.1.3具体的选泵步骤如下: 11 3.2泵的