建新煤矿0.9Mta新井设计【毕业论文+CAD图纸全套】.doc

摘 要一般部分为Mt新井设计。该煤矿位于省市面，交通便利。井田走向（东西）长约，倾向（南北）长约，。主采煤层为号煤，平均倾角为°，煤层平均总厚为m。井田地质条件较为简单。 井田工业储量为Mt，矿井可采储量Mt。矿井服务年限为a，涌水量不大，矿井正常涌水量为m3/h，最大涌水量为m3/h。矿井瓦斯相对涌出量47 m3/t m3/t，为瓦斯矿井。 井田为立井水平开拓。大巷采用胶带运输机运煤，辅助运输采用矿井通风方式为通风。矿井年工作日为330d，工作制度为“三八”制。 一般部分共包括10章：1.矿区概述及井田地质特征2.井田境界和储量3.矿井工作制度及设计生产能力、服务年限4.井田开拓5.准备方式-区巷道布置6.采煤方法7.井下运输8.矿井提升9.矿井通风与安全技术10.矿井技术经济指标。专题部分题目翻译部分主要内容Study on destressing technology for a roadway driven along goaf In a fully mechanized top-caving face 关键词：工业储量 ；立井开拓 ；工作制度 ；采煤方法 ；矿井通风  Abstract: The design is made of three parts: general part, special part, and translation. The general part is the design of a new mine with a volume of 0.9mt in Jianxin Minging CO;Ltd.in Fengcheng. Jianxin Minging CO;Ltd. locates in the southeast of Fengcheng. The traffic there is very convenient. The minefield is about 3.5kms long(from east to west) and about 4.0kms wide(from north to south), with an area of 12 square kms.The main exploited coal bed is NO.4, which has an average dip of 9’. The average thickness of the coal bed is 3.5m. so, it’s clear that the geological terms are very simple there. The industrial reserves of the mine are 77.5mt, the exploitative reserves of the mine are 56.1mt. the service period of the mine are 58a. The gushing capacity of the mine is not very huge, with a normal volume of 25-35m3/h and a maximum volume of 107m3/h. the mine, with a relative volume of 45.7m3/t gas gushing out,can be named high-gas mine. vehicles with fixed trunk weighing 1.5t can be adopted in big tunnels, and also be used as supplementary haulage. The pattern of ventilating is center-boundary ventilation. The mine is estimated to work 330days in a year, with “8hours, 3shifts”working regulation. There are ten chapters in the general part. Chapter one：introduction of mine area and geological features of mine. Chapter two:boundary and reserve of the mine Chapter three:working regulation, production capacity and service period Chapter four: development chapter five:preparing