9F燃机启动调试步骤.docVIP

Day/Date 天/日期 Test试验 Purpose of Test试验目的 Test activities试验活动 Remarks备注 Day 1 第1天 11/08/2006 Rotor run-in: 转子试转： Crank test摇转试验 Listen for rubs or unusual noises听是否有摩擦和异常噪音 Functional test of emergency trip button紧急跳闸按钮的功能试验 Purge speed cranking for rotor vibration check以吹扫速度摇转，检查转子振动情况 Monitor LCI starting temperatures and operation监视器LCI起动温度和运行 Air blowing the purge piping of D5 and PM4 gas fuel during crank摇转期间给D5和PM4吹扫管鼓风 Check operation of lift oil and turning gear 检查顶轴油和盘车的运行 Roll up to 50 rpm trip by DCS emergency push button and 200 rpm and trip by GT MK 6 control emergency stop通过DCS紧急按钮逐渐增加到50rpm，通过GT MK6控制紧急停机跳闸 Restart, accelerate to go to Purge speed for 5min and select normal stop重起，加速到吹扫速度5分钟，选择正常停止 Restart, hold at purge speed and air blowing the piping of D5 and PM4, trip by DCS customer trip (L4CT) after 30 Min crank test重起，保持在吹扫速度，给D5和PM4管道鼓风，在30分钟摇转试验后通过DCS客户跳闸（L4CT）跳闸 Verify coast down to turning gear核实惰行至盘车 Monitor vibration levels through out the test period监视整个试验期间的振动级 Use auto start-up sequences to prepare the unit for a “Ready-to-Start”采用自动走动顺序将机组准备好“准备起动” Rub checks are performed 检查摩擦 ADRE vibration monitor to be connected 连接ADRE振动监视器 After Shut-down停机后 Reinstate the piping spool of D5 and PM4 pipe work after shutdown停机后重新恢复D5和PM5管子的导管 Day 1 第1天 11/08/2006 Rotor run-in: 转子试转： False firing, actual first firing and FSNL假点火，实际第一次点火和FSNL False fire假点火 Actual First Fire to FSNL 实际第一次点火至FSNL Select fire for false fire and check unit for gas leaks, and P2 pr. Check选择假点火的火，检查机组是否漏气，和P2。检查 Verify unit trip and coast down to turning gear核实机组跳闸，惰行至盘车 Actual first firing and check for gas leaks at firing speed实际第一次点火，检查点火速度时是否漏气 Acceleration unit up to FSNL and stabilized min 4 hours thermal soak Start up heater commissioning将机组加速到FSNL，至少稳定4小时热浸泡 Normal down unit and keep turning gear on for natural cooldown.机组正常停机，保持盘车，自然冷却 Monitor vibration levels through out the test period监视整个试验期间的振动级 After Shut-down停机后 1. Install balan