MEASURING SYSTEMS AND TOOLS Textbooks测量系统和工具教科书.pptVIP

TECH TIP: The Weirder the Problem, the More Likely It Is a Poor Ground Connection Bad grounds are often the cause for feedback or lamps operating at full or partial brilliance. At first the problem looks weird because often the switch for the lights that are on dimly is not even turned on. When an electrical device is operating and it lacks a proper ground connection, the current will try to find ground and will often cause other circuits to work. Check all grounds before replacing parts. * TAILLIGHT BULB REPLACEMENT 1 The driver noticed that the taillight fault indicator (icon) on the dash was on any time the lights were on. * TAILLIGHT BULB REPLACEMENT 2 A visual inspection at the rear of the vehicle indicated that the right rear taillight bulb did not light. Removing a few screws from the plastic cover revealed the taillight assembly. * TAILLIGHT BULB REPLACEMENT 3 The bulb socket is removed from the taillight assembly by gently twisting the base of the bulb counterclockwise. * TAILLIGHT BULB REPLACEMENT 4 The bulb is removed from the socket by gently grasping the bulb and pulling the bulb straight out of the socket. Many bulbs required that you rotate the bulb 90° (1/4 turn) to release the retaining bulbs. * TAILLIGHT BULB REPLACEMENT 5 The new 7443 replacement bulb is being checked with an ohmmeter to be sure that it is okay before it is installed in the vehicle. * TAILLIGHT BULB REPLACEMENT 6 The replacement bulb in inserted into the taillight socket and the lights are turned on to verify proper operation before putting the components back together. * OPTICAL HEADLIGHT AIMING 1 Before checking the vehicle for headlight aim, be sure that all the tires are at the correct inflation pressure, and that the suspension is in good working condition. * OPTICAL HEADLIGHT AIMING 2 The headlight aim equipment will have to be adjusted for the slope of the floor in the service bay. Start the process by turning on the laser light generator on the s