Product Marketing apps产品营销应用程序.bullard.pptVIP

Clean Air Box Usage Care CAB Usage Care CAB Set Up Calibration Operation Remote Alarm Shut Down Monitor Battery Replacement CO Sensor Replacement Filters Drains AA Battery Backup CAB Set Up (Steps 1-3) CAB Set Up (Steps 4-6) Zero Point Calibration (Steps 1-5) Zero Point Calibration (Steps 6-12) Calibration (Steps 1-3) Zero Point Calibration (Steps 4-10) Remote Alarm CAB Shutdown (Steps 1-3) CAB Shutdown (Steps 4-5) CAB Shutdown (Steps 6-8) CO Monitor Battery Replacement CO Monitor Sensor Replacement Filter Usage Care AA Battery Back Up Support Call 877-BULLARD Visit * * CABs RAMs CO Monitors (1) Attach to Incoming Air Source (Do not exceed 150 psi) (2a) Connect to AC Power Source (Fixed Panels may be hard wired) (2b) Unit may be operated on (8) AA batteries if no AC power source is available (3) Flip Control Box Switch to On Position (4) Remove the CO Monitor cover and press the On Button (5) Wait for 60 second countdown / boot up (6) If unit has been recently calibrated then set monitor to Run mode, otherwise proceed to calibration steps (1) Zero with impurity free test gas (3) AC will appear on LCD screen (2) With cover off and Monitor On, rotate knob to Cal position (4) Press and hold On/Off button until beep sounds (5) AO will appear on LCD screen (6) Attach regulator to the zero gas cylinder (7) Insert calibration connector fitting into the center hole of the CO Monitor knob (8) Open the cylinder valve fully (9) The Red LED will blink for approximately 90 seconds while the zero process is completed (10) Green LED will blink to indicate successful zero point calibration (11) Close the gas cylinder and remove the connector fitting from the monitor (12) Rotate CO Monitor knob to Run (1) Select 5 ppm or 10 ppm test gas (3) AC will appear on LCD screen (2) With Cover off and Monitor On, rotate knob to Cal position (4) Attach regulator to the test gas cylinder (5) Insert calibration connector fitting into the center hole of the CO monitor knob (6) Open the cyl