nameofprimegeneralcontractor.docVIP

NAME OF GENERAL CONTRACTOR PROJECT-SPECIFIC SAFETY PLAN NAME OF PROJECT LOCATION ADDRESS DATE: January 2008 D I S C L A I M E R The information contained herein was prepared and presented with reasonable care and is based on the most reliable information available to the author. The Commission makes no warranty, expressed or implied, of the fitness, accuracy or completeness of this information. Judgments as to the suitability of the information herein for the user’s purposes are necessarily the user’s responsibility. I N T R O D U C T I O N The Contractor shall have sole and complete responsibility for the implementation of a worksite safety plan and shall take necessary precautions for the health and safety of employees and fully comply with applicable provisions of all sections of 29 CFR 1926-OSHA Construction Industry Safety and Health Standards, 29 CFR 1910-OSHA General Industry Safety and Health Standards, National Fire Protection Association codes, City of Chicago Fire Prevention Code, National Electrical Code, all applicable American National Standards Institute standards, City of Chicago Building Code, and all standards or codes referred to in the listed document and any other applicable standards. Due to the changing nature of health and safety regulations, and because new information is constantly becoming available, this plan is subject to change.  TABLE OF CONTENTS D I S C L A I M E R 1 I N T R O D U C T I O N 1 Project-Specific Safety Plan (PSSP) 4 1.1 Workplace Safety and Health Policy 4 1.2 The Project-Specific Safety Plan (PSSP) 4 1.3 General Contractor and Subcontractor Safety Plans 4 Section 2 – Scope of Work 5 2.1 Scope of Work 5 2.2 Project-Specific Safety Plan Application 5 Section 3 – Project Safety Management Responsibilities and Authority 7 3.1 Safety Responsibilities 7 Section 4 – Administrative Phase 8 4.1 Project Safety and Health Committee 8 4.2 Safety Orientation 8 4.3 Awareness Campaign 9 4.4