实验4激光干涉仪测量位移实验-.pptVIP

Institute of Computer Software Nanjing University Institute of Computer Software Nanjing University Institute of Computer Software Nanjing University Institute of Computer Software Nanjing University * * 干涉仪实验 * * Michelson interferometer Sliver mirror Sliver mirror Sliver mirror with piezo Sliver mirror HeNe source Equipment * * Equipment list He-Ne laser source Silver mirror Pizzo and controller with power source Beam splitter Detectors Oscilloscope Analog signal source Other essential equipment in the optical experiment Step 1 * * Set up the HeNe laser source and make sure the beam can incident to the first collimation mirror in a straight line. Step 2 * * Set up the second collimation mirror and then moving the beam to the other line and pass through the Iris Step 3 * * Using 2 Irises to collimate the beam. As shown in the picture, just confirm the beam light can across these two Iris perfectly. Step 4 * * Assembling the beam splitter and first reflect silver mirror according to the picture in this page. Step 5 * * Implement the second reflect mirror with Piezo and make sure all the reflect beam can be intersected in the beam splitter. Step 6 * * Set up the detector to receive the coherent beam from the beam Splitter and connect the detector To the OSC and power supply. After that, all the preparations are finished. Then, connect the analog signal source to the piezo power supply to start the experiment. Piezo system tips * * How to build up a piezo system? In order to drive a piezo,it is need a power supply and signal source. And also need a software APT to control the power supply. In this experiment we are using the software download from ‘Thorlabs’ /software_pages/viewsoftwarepage.cfm?code=APT Hardware connection can be find below: Output Signal Source Set up the APT * * Connect a 0-10V external source to the EXT IN connector on the rear panel. In the GUI panel, click the ‘Settings button to display the settings panel. I