Ohmic-like contact formation at the rear interface between Cu(In,Ga)Se2 and ZnOAl in a lift-off Cu(In,Ga)Se2 solar cell.pdfVIP

下载本文档

5
0
约3.06万字
约 6页
2017-03-16 发布于天津
举报
版权申诉

Ohmic-like contact formation at the rear interface between Cu(In,Ga)Se2 and ZnOAl in a lift-off Cu(In,Ga)Se2 solar cell.pdf

1、本文档共6页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
5、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
6、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
7、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
8、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

Ohmic-like contact formation at the rear interface between Cu(In,Ga)Se2 and ZnOAl in a lift-off Cu(In,Ga)Se2 solar cell.pdf

Thin Solid Films 616 (2016) 17–22 Contents lists available at ScienceDirect Thin Solid Films journal homepage: /locate/tsf Ohmic-like contact formation at the rear interface between Cu(In,Ga)Se2 and ZnO:Al in a lift-off Cu(In,Ga)Se2 solar cell Jakapan Chantana ?, Hiroyuki Arai, Yutaka Niizawa, Takashi Minemoto Department of Electrical and Electronic Engineering, Ritsumeikan University, Kusatsu, Shiga 525-8577, Japan article info Article history: Received 12 February 2016 Received in revised form 26 July 2016 Accepted 28 July 2016 Available online 30 July 2016 Keywords: Copper indium gallium selenide Lift-off solar cells Ohmic-like contact Trap-assisted tunneling recombination Bi-layers of back electrode abstract A lift-off Cu(In,Ga)Se2 (CIGS) solar cell, which could serve as the top solar cell in a tandem-type solar cell, was fabricated with a superstrate-type structure consisting of soda-lime glass (SLG)/epoxy/Al/n-type ZnO:Al (AZO)/ZnO/CdS/p-type CIGS/n-type AZO (back electrode)/Al. This study proposes a method of realizing the ohmic-like contact between p-type CIGS and n-type AZO in a lift-off CIGS solar cell to improve the conversion ef?ciency (η). The sputtering conditions under which the n-type AZO layer was deposited, speci?cally the sample position and radio frequency (RF) power density, were optimized to form ohmic-like contact through trapassisted tunneling recombination. The sputtering damage near the CIGS surface that induced the trap-assisted tunneling recombination was evaluated by examining the photoluminescence peak intensity. Ultimately, ohmic-like characteristics were attained for the p-type CIGS/n-type AZO interface under optimal AZO deposition conditions, with the sample positioned 0 cm from the AZO target center and an RF power density of 2.4 W/cm2. The proposed method was successfully applied to the fabrication of a lift-off CIGS solar cell. Consequently, an η value of 9.2% was obtained for the lift-off CIGS solar cell, which is 70% that of a s