应变计伺服液压缸测试方法研究.pdfVIP

第41卷第1期 中国测试 Vol.41 No.1 2015年 1月 CHINA MEASUREMENT TEST January，2015 doi院10.11857/j.issn.1674-5124.2015.01.004 应变计伺服液压缸测试方法研究 涂福泉袁 胡良智 （武汉科技大学冶金装备与控制教育部重点实验室，湖北 武汉 430081） 摘 要院 针对原有轧机伺服液压缸高频动态响应测试系统的不足，提出一种基于应变计的新型测试方法。运用 ANSYS有限元软件得到机架表面适用于实验的应变测点，并利用现有轧机伺服液压缸实验设备，制定合理的实验方 法和流程，进行液压缸测试实验。结果表明：应变-位移曲线和载荷-位移曲线均呈很好的线性关系，重复性好，可以满 足现有轧机伺服液压缸高频动态响应测试系统的要求。 关键词院伺服液压缸；应变计；应变测点；高频动态响应测试 文献标志码院A 文章编号院1674-5124渊2015冤01-0013-03 Study of servo hydraulic cylinder test method based on strain gauge TU Fuquan，HU Liangzhi （Key Laboratory of Metallurgical Equipment and Control Technology of Ministry of Education， Wuhan University of Science and Technology，Wuhan 430081，China） Abstract: A new test method based on strain gauge was proposed to overcome some shortcomings of the original mill hydraulic servo-cylinder test system. And some experimental aircraft surface strain measurement points were gained with ANSYS. Then the reasonable experimental methods and processes were developed for the hydraulic cylinder testing laboratory by utilizing the present hydraulic experimental facilities. The test suggests that the strain - displacement and the load - displacement curves show a good linear relationship，and experimental results are satisfactory reproducibility. The results show that the new test method can meet the requirements of the frequency dynamic response of the existing mill servo cylinder test system. Keywords: servo-cylinder hydraulic；strain gauge；stain measurement points；high frequency dynamic response test 0 引 言 态性能测试；因此，深入开展高频液