道康宁产品在涂料和油墨中的应用剖析.ppt

* * * * * * * * * * On one hand, if the material is too hydrophobic, it may be too incompatible with the coating as it dries, leading to unsightly defects caused by dewetting (cissing, fisheyes etc). On the other hand, if the material is too hydrophilic, it will not cause dewetting defects, but it will prefer to be dispersed throughout the aqueous medium, rather than situated at the air/water microbubble interface. This means it cannot be carrying out its function, which is to destroy foam, so the dried film will contain bubbles, craters and pinholes etc. This is the challenge faced by additive manufacturers, finding the correct balance of materials to give the correct balance of properties. * 主要用于溶剂型涂料体系。有机改性有机硅 * 乳液 * 乳液 * 混合物 * 混合物 * 油类 * 唯一一只颜料分散剂 * 200-500nm，pH=11，自身也可以成膜 Now I am going to be moving on to some technologies that for more niche applications. First is the silicone water-based elastomers which are aqueous dispersions of silicone rubber particles that coalesce irreversibly upon evaporation of water to form a silicone elastomer. These elastomers are cured by the removal of water. These additives are used as water repellency additives by forming this film with in the coating. What I mean by this is that they prevent liquid water from penetrating the coating, but they do allow the coating to breath by allowing the passage of water vapor. These additives are resistant to ultraviolet light along with being acid and alkali splash resistant. These materials can be blended with acrylics to improve the elastomeric properties of the acrylics and the water repellent properties. They also can be pigmented and they have great adhesion to wood, concrete, masonry, and glass. These films are recoatable with itself but can not be painted with water-based organics. These emulsion polymers are stabilized with anionic surfactants and the particle size is about 200-500 nm. The pH of these additives is about 11. The emulsions are supplied at 60% water and has an ex