圆锥破碎机 毕业设计论文外文文献翻译.docVIP

附录A Cone Crushers Cone Crusher is suitable to crush various kinds of ores and rocks of medium or above medium hardness.Compared with Jaw Crusher, Spring Cone Crusher is of stable structure, high efficiency, easy adjustment,and economical using etc. The spring safety system of crusher acts as an overloading protection system that allows metals to pass through the crushing chamber so as not to damage the Cone Crusher. The safety system uses dry oil and water as two kinds of sealed formation to make plaster powder and engine oil separated to make sure reliable performance. This type of crushing chamber depends upon the size offeeding and fineness of the crushed product. The standard type (PYB) is applied to medium crushing, themedium type is applied to medium or fine crushing and the short head type is applied to fine crushing. Working Principle of Spring Cone Crusher: Spring Cone Crusher crushes materials by the working surface between the movable cone and fixed cone.So it is more advanced and efficiency than Jaw Crusher. The movable cone is supported by spherical bearing and fixed on an hanging erect shaft which is set in the eccentric sleeve, and the sleeve is set on the stopping and pushing bearing. The movable cone and erect shaft are driven by the eccentric shaft sleeve together. The eccentric shaft sleeve is driven by horizontal shaft and fimbriated gear, and thwheelof the conveyor belt is driven by motor through v-belts. The lower part of vertical shaft is installed in theeccentric sleeve. When the eccentric sleeve rotates, there is a conical surface lined out by the shaft. When the movable cone comes near the fixed cone, rocks are grinded into pieces, when the cone leaves, grindedmaterials is discharged from the discharge hole. The fixed cone can be ascended or descended by adjusting setting to adjust the width of discharge hole; consequently the output Intense competition and strong fluctuations in the price of raw mate