CATIA V5经典练习题1-GSD_Mobil_Phone_V5.docVIP

Generative Shape Design Detailed StepsTable of Contents Mobile Phone 4 Step 1: Creating the Wireframe Geometry 4 Step 2: Creating the Surfaces 9 Step 3: Performing operations 16 Step 4: Analyzing and Modifying 26 Step 5: Completing the part in Part Design 34 Mobile Phone Step 1: Creating the Wireframe Geometry Load the part called CATGSD_F_Phone_Step1_start.CATPartfrom the Companion and save the part in the Students directory. 1. You are going to extract the elements that will be necessary to complete the wireframe geometry: Double-click on the Extract icon Select the elements to be extracted (two pink edges and the yellow face) : Click Cancel to close the Extract dialog box. 2. You are going to use these extracted elements to create the wireframe geometry: Click on the Parallel Curve icon . Select the shortest pink extracted curve as element to offset, and the yellow face as support: Click OK to confirm. Click on the point creation icon . Select the “on curve” type and the previous parallel curve as support. Create this point: Click on the Parallel Curve icon . Select the second pink extracted curve as element to offset, and the yellow face as support: Click on the Parallel Curve icon . Select the first pink extracted curve as element to offset and the yellow face as support: Click on the Connect Curve icon . Create this connect curve: Click on the project icon and project the previous connect curve to the yellow extracted face: Click on the corner icon and create a corner between the these two curves (the shortest parallel curve and the projected curve): Click on the point icon and create a point on the YZ plane using these parameters: Click on the circle icon and create a circle using the previous point as center, YZ plane as support and the following parameters: Step 2: Creating the Surfaces Load the part called CATGSD_F_Phone_Step2_start.CATPart from the Companion and save the part in the Students directory. 1. Insert