5_S12 SW Upgrade Implementation.pptVIP

BSC S12 Software PCU2 Upgrade and Feature Activation S12 SW Upgrade Implementation S12 SW Upgrade Implementation After learning this module the participant will be able to: Describe the memory requirements for the S12 SW Upgrade Identify the basic steps of the SW upgrade Understand the preparation requirements needed for the SW upgrade Perform a major BSC software upgrade to S12 S12 SW Upgrade Implementation The BSC S12 upgrade consists of the following tasks: Safe-copying of the current software package Pre-checking of the BSC Firmware change and memory upgrade Copy the new software Actual upgrade Post-checking of the configuration Safecopy of new software package S12 SW Upgrade Implementation Needed equipment for a successful upgrade: S12 implementation procedure (this document) Safecopy instructions of DX200 BSC for S11/S11.5 (can be found from NED) Safecopy instructions of DX200 BSC for S12 (can be found from NED) Change Deliveries for the S12 software PC with installed HIT and upgrading macros 2 PCs with installed terminal communication software HIT Users manual TCSM2 documents (if TCSM2 is configured to the current BSC) The password of the BSC with full authority 250 in all command classes SIM cards of the network S12 SW Upgrade Implementation HIT S12 software is upgraded using the HIT (Holistic Integration Tester) software tool HIT software is a Microsoft Windows? based tool, which automates most of the tasks necessary for the software upgrade System requirements for HIT HIT 2.8swup version designed to operate on Windows 2000, Windows NT, Windows 98 and Windows 95 The HIT installation requires approximately 11.8MB disk space, of which the documentation occupies approximately 5MB S12 SW Upgrade Implementation S12 SW Upgrade Implementation HIT Upgrade script (UPRUPG12.HIT) allows any upgrade from S11 or S11.5 to S12 release There are three connection options in the S12 Sw upgrade: Local Serial Port Telnet / LAN Remote If the “Local Serial Port” is sele