lecture-AbaqusStandard中的非线性分析.ppt

Introduction to Abaqus/Standard and Abaqus/Explicit CONVERGENCE TOLERANCE PARAMETERS FOR MOMENT CRITERION FOR RESIDUAL MOMENT FOR A NONLINEAR PROBLEM 5.000E-03 CRITERION FOR ROTATION CORRECTION IN A NONLINEAR PROBLEM 1.000E-02 INITIAL VALUE OF TIME AVERAGE MOMENT 1.000E-02 AVERAGE MOMENT IS TIME AVERAGE MOMENT ALTERNATE CRIT. FOR RESIDUAL MOMENT FOR A NONLINEAR PROBLEM 2.000E-02 CRITERION FOR ZERO MOMENT RELATIVE TO TIME AVRG. MOMENT 1.000E-05 CRITERION FOR RESIDUAL MOMENT WHEN THERE IS ZERO FLUX 1.000E-05 CRITERION FOR ROTATION CORRECTION WHEN THERE IS ZERO FLUX 1.000E-03 CRITERION FOR RESIDUAL MOMENT FOR A LINEAR INCREMENT 1.000E-08 FIELD CONVERSION RATIO 1.00 VOLUMETRIC STRAIN COMPATIBILITY TOLERANCE FOR HYBRID SOLIDS 1.000E-05 AXIAL STRAIN COMPATIBILITY TOLERANCE FOR HYBRID BEAMS 1.000E-05 TRANS. SHEAR STRAIN COMPATIBILITY TOLERANCE FOR HYBRID BEAMS 1.000E-05 SOFT CONTACT CONSTRAINT COMPATIBILITY TOLERANCE FOR PP0 5.000E-03 SOFT CONTACT CONSTRAINT COMPATIBILITY TOLERANCE FOR P=0.0 0.100 DISPLACEMENT COMPATIBILITY TOLERANCE FOR DCOUP ELEMENTS 1.000E-05 ROTATION COMPATIBILITY TOLERANCE FOR DCOUP ELEMENTS 1.000E-05 非线性悬臂梁分析的输出 Introduction to Abaqus/Standard and Abaqus/Explicit TIME INCREMENTATION CONTROL PARAMETERS: FIRST EQUILIBRIUM ITERATION FOR CONSECUTIVE DIVERGENCE CHECK 4 EQUILIBRIUM ITERATION AT WHICH LOG. CONVERGENCE RATE CHECK BEGINS 8 EQUILIBRIUM ITERATION AFTER WHICH ALTERNATE RESIDUAL IS USED 9 MAXIMUM EQUILIBRIUM ITERATIONS ALLOWED 16 EQUILIBRIUM ITERATION COUNT FOR CUT-BACK IN NEXT INCREMENT 10 MAXIMUM EQUILIB. ITERS IN TWO INCREMENTS