2-2的操作与配置CìscoIOS设备—启动路由器.pptVIP

通过完成这一节的学习，你将能够： 启动一台路由器并认识正常的启动顺序 在Cisco路由器上，使用命令行接口(CLI)与Cisco IOS软件进行交互 使用命令行接口(CLI)提供的在线帮助工具 福建金科集团网络工程师系列教程 福建金科集团网络工程师系列教程 启动路由器 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 目标 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Cisco路由器的初始启动 系统启动程序初始化路由器软件 如果需要，路由器的启动顺序是可以选择的 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 路由器启动时的输出 未配置和已配置的路由器启动对比 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Setup：初始配置对话 Router#setup --- System Configuration Dialog --- Continue with configuration dialog? [yes/no]: yes At any point you may enter a question mark ? for help. Use ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets []. Basic management setup configures only enough connectivity for management of the system, extended setup will ask you to configure each interface on the system Would you like to enter basic management setup? [yes/no]: no Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 浏览接口摘要 First, would you like to see the current interface summary? [yes]: Interface IP-Address OK? Method Status Protocol BRI0 unassigned YES unset administratively down down BRI0:1 unassigned YES unset administratively down down BRI0:2 unassigned YES unset administratively down down Ethernet0 unassigned YES unset administratively down down Serial0 unassigned YES unset administratively down down 在启动过程中找到的接口 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 设置初始全局参数 Configuring global parameters: Enter host name [Router]:ccna_lab The enable secret is a password used to protec