Bsc技术交流资料教学.pptVIP

* * 注释：BSC在硬件结构上还有一个shelf的说法，指的是BSC每一层，上图为例，有5个shelf * * The duplicated Group Switch (GSWB) 256 is the switching fabric of the BSC3i. The GSWB is housed in two identical SW1C-C cartridges, and it conveys the traffic passing through the BSC3i and switches the tones to the subscribers of the exchange and to the trunk circuits. It also establishes the needed connections to the signalling units and the internal data transmission channels, and is responsible for the submultiplexing functions of the BSC3i. The operation of the GSWB is controlled and supervised by the Marker and Cellular Management Unit (MCMU; SWCOP-A). Redundancy: 2n with MCMU Type: Functional unit, sub-unit of the Marker and Cellular Management Unit Plug-in units: SW64B Switching Network (8 Bit/s channels) PSC1-S Power Supply for Cartridge The dimensions of an SW1C-C cartridge are (height x width): 270 mm x 198 mm The dimensions of the plug-in units are (height x width): 233.4 mm x 220 mm; or 9.19 in x 8.66 in. The CLS generates the clock signals necessary for the BSC. The oscillator of the CLS is normally synchronized to an external source, usually an MSC, through a PCM line. Up to three additional PCM inputs are provided for redundancy. Plug-in Unit: CL3TG (Clock and Tone Generator) Interfaces: Synchronization input from Transcoder External synchronization input Synchronization output Wired alarm interface to OMU via GSWB The ClockTone Generator (CL3TG) plug-in unit meets the requirements of the ITU-T Q.500 Series Recommendation with respect to the Time Interval Error (TIE), the jitter, the wander, and the transfer function. In the plesiochronous operation mode, the frequency shift of the CL3TG is 5 * 10-9 within each 24-hour period, if the temperature of the environment does not vary. CL3TG with external synchronised input is available by using the external synchronisation input connector from the CPRJ45 panel. It can be implemented either by symmetrical or asymmetrical PCM connec