RP-090746_Annex C2 Link budget template_LOS.doc

FDD RIT component of SRIT “LTE Release 10 beyond (LTE-Advanced)” (Source RP-090746) TABLE 1 Link budget template for indoor test environment(indoor hotspot deployment scenario) (See 3GPP note at bottom of the table) Item Downlink Uplink System configuration Carrier frequency (GHz) 3.4 3.4 BS antenna heights (m) 6 6 UT antenna heights (m) 1.5 1.5 Cell area reliability(1) for control channel (%) (Please specify how it is calculated.) (See 3GPP note at bottom of the table (i) ) 95% 95% Cell area reliability(1) for data channel (%) (Please specify how it is calculated.) (See 3GPP note at bottom of the table (i) ) 90% 90% Transmission bit rate for control channel (bit/s) 44000 4000 Transmission bit rate for data channel (bit/s) 4125600 928800 Target packet error rate for the required SNR in item (19a) for control channel 1% 1% Target packet error rate for the required SNR in item (19b) for data channel 10% 10% Spectral efficiency(2) (bit/s/Hz) 0.23 0.52 Pathloss model(3) (select from LoS or NLoS) LoS LoS Mobile speed (km/h) 3 3 Feeder loss (dB) 2 2 Transmitter (1) Number of transmit antennas. (The number shall be within the indicated range in Table 6 of Report ITU-R M.2135) 2 1 (2) Maximal transmit power per antenna (dBm) 18 21 (3) Total transmit power = function of (1) and (2) (dBm) (The value shall not exceed the indicated value in Table 6 of Report ITU-R M.2135) 21 21 (4) Transmitter antenna gain (dBi) 0 0 (5) Transmitter array gain (depends on transmitter array configurations and technologies such as adaptive beam forming, CDD (cyclic delay diversity), etc.) (dB) 0 0 (6) Control channel power boosting gain (dB) 0 0 (7) Data channel power loss due to pilot/control boosting (dB) 0 0 (8) Cable, connector, combiner, body losses, etc. (enumerate sources) (dB) (feeder loss must be included for and only for downlink) 3 1 (9a) Control channel EIRP = (3) + (4) + (5) + (6) – (8) dBm 18 20 (9b) Data channel EIRP = (3) + (4) + (5) – (7) – (8) dBm 1